1978 International Harvester SCOUT SERIES: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
2 distinct recall campaigns
Not available median reported failure mileage
Scope: 1978 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
2 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
78V100000 · Electrical System:Wiring: Rear Compartment/Trunk
Reported: 1978-05-03 (May 3, 1978)
THE WIRING HARNESS MAY HAVE BEEN ENTRAPPED, OUT OF POSITION, IN A PINCHED CONDITION AT A FRAME OUTRIGGER DURING ASSEMBLY OF THE BODY CHASSIS. THE TRAILER FEED WIRE IS NOT PROTECTED BY A FUSE OR CIRCUIT AND IS SUSCEPTIBLE TO A SHORT CIRCUIT OCCURRENCE.
Remedy: THE DEALER WILL INSPECT VEHICLES FOR THIS PINCHED CONDITION, ADD CLIPPING TO ENSURE POSITIVE LOCATION OF WIRING HARNESS AND PROPER SEPARATION FROM FUEL LINE AT OUTRIGGER AND INSTALL A CIRCUIT BREAKER ON THE TRAILER FEED WIRE AT NO CHARGE.
NHTSA campaign record ↗79V050000 · Fuel System, Gasoline:Delivery
Reported: 1979-02-21 (February 21, 1979)
DUE TO INCORRECT CLIPPING OF THE FUEL LINE AT THE RIGHT FRONT INNER FENDER SPLASH PANEL, THE LINE COULD SEVER OR BECOME PARTIALLY CUT BY THE LOWER EDGE OF THE SPLASH PANEL, IN THE EVENT OF A VEHICLE IMPACT. THESE VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 301, "FUEL SYSTEM INTEGRITY".
Remedy: DEALER WILL INSPECT FUEL LINE CLIPPING AND, IF NECESSARY, CLIP TO THE PROPER LOCATION.
NHTSA campaign record ↗