1994 Chevrolet C10: complaints, problems and recalls

VEHICLE EXPERIENCED THE SAME DEFECT WITH ITS WINDSHIELD WIPER WIRING AS STATED IN RECALL 98 V 150 001; BUT THIS VEHICLE WAS NOT INCLUDED IN RECALL DUE TO VIN. *AK

Owner-reported narrative. 80,000 miles reported. Look up ODI 10024070 at NHTSA ↗

WINDSHIELD/WIPER FAILURE ON 1994 CHEVROLET C10. NOTICED ON NHTSA'S WEBSITE THAT THERE IS A RECALL # 98V150001 AND ALSO A RECALL NOTICE FROM CONSUMER REPORT INVOLVING THIS PROBLEM. CHEVY ADVISED THAT THERE IS NOT CURRENT RECALL FOR THIS PROBLEM. WIPERS WILL INTERMITTENTLY WORK. *LA

Owner-reported narrative. Look up ODI 10047332 at NHTSA ↗

ENGINE RUNS ROUGH, MISFIRES WHEN ACCELERATING.

Owner-reported narrative. Look up ODI 507827 at NHTSA ↗

WHEN DRIVING AND WINDSHIELD WIPERS WERE NEEDED, THEY WERE INOPERABLE, CAUSING POOR DRIVER'S VISIBILITY. RECALL 98V150000 DEALS WITH SAME PROBLEM. HOWEVER, CONSUMER'S VEHICLE IS NOT INCLUDED IN RECALL DUE TO VIN. WINDSHIELD WIPERS WORK SPORADICALLY. CONSUMER REPAIRED PROBLEM HIMSELF. *JG

Owner-reported narrative. Look up ODI 8002914 at NHTSA ↗

CONSUMER STATES WHILE DRIVING IN THE RAIN THE WINDSHIELD WIPER INTERMITTENLY WORKS. MR

Owner-reported narrative. Look up ODI 8020966 at NHTSA ↗

VEHICLE EXPERIENCED SAME PROBLEMS AS STATED IN RECALL 98V150001/ WINDSHIELD WIPERS WORKING INTERMITTENTLY, SOLDIER JOINTS NEAR WIRING HARNESS CONNECTOR CRACKED. MANUFACTURER ADVISED CONSUMER THAT THIS VEHICLE WAS NOT A PART OF RECALL DUE TO VIN. *AK *SLC

Owner-reported narrative. Look up ODI 889490 at NHTSA ↗

98 V 150 001/ 98 V 150 000/WINDSHIELD WIPER WIRING: WINDSHIELD WIPERS WORK INTERMITTENTLY. THIS CAN RESULT IN INOPERATIVE WIPERS, REDUCING DRIVER'S VISIBILITY, AND INCREASING RISK OF A VEHICLE CRASH. DEALER WAS NOTIFIED, AND INFORMED CONSUMER THAT VEHICLE WAS NOT COVERED UNDER RECALLS DUE TO VIN. *AK CONSUMER STATES WIPERS WILL WORK IF YOU TAP ON THE WIPER MOTOR, CONSUMER ALSO STATES HIS WIPER SYMPTOMS ARE THE EXACT SAME AS WHAT IT STATES IN THE RECALL. *SLC

Owner-reported narrative. Look up ODI 894392 at NHTSA ↗

VEHICLE STALLS INTERMITTENTLY WHILE TRAVELING DOWN THE HIGHWAY. TT

Owner-reported narrative. Look up ODI 967006 at NHTSA ↗

Reported: 1993-09-15 (September 15, 1993)

THE BRAKE PEDAL PUSH ROD RETAINER IS MISSING, MISPOSITIONED OR NOT PROPERLY SEATED.

Consequence: BRAKE PEDAL PUSH ROD PROBLEMS CAN CAUSE THE STOP LAMPSWITCH AND THE BRAKE BOOSTER PUSH ROD TO DISCONNECT FROM THE BRAKE PEDAL,RESULTING IN LOSS OF BRAKE OPERATION, AND A VEHICLE CRASH COULD OCCUR WITHOUTPRIOR WARNING.

Remedy: INSPECT VEHICLES TO ASSURE THE BRAKE PEDAL PUSH ROD RETAINER IS PRESENT AND FULLY SEATED IN ITS CORRECT POSITION.

Reported: 1993-12-14 (December 14, 1993)

THE SEATS HAVE BEEN ASSEMBLED WITHOUT BOLTS THAT CONNECT THE UPPER SLAVE HINGE TO THE SEAT BACK FRAME, OR WITHOUT BOLTS THAT CONNECT THE SEAT TO THE SEAT ADJUSTER. IN EITHER CASE, THE VEHICLES FAIL TO CONFORM TO FNVSS NO. 207, "SEATING SYSTEMS."

Consequence: THE MISSING BOLTS MAY CAUSE THE DRIVER'S SEAT TO BECOMELOOSE AND IN A SUDDEN STOP OR ACCIDENT MAY SUBJECT THE OCCUPANT TO INCREASEDRISK OF INJURY.

Remedy: DEALERS WILL INSPECT SEATS FOR MISSING BOLTS AND INSTALL BOLTS IF REQUIRED.

Reported: 1994-04-05 (April 5, 1994)

TRUCKS WERE ASSEMBLED WITH THE LEFT-HAND LOWER CONTROL ARM TO FRAME REAR NUT TIGHTENED BELOW THE SPECIFIED TORQUE. LOW TORQUE ON THIS NUT MAY ALLOW THE ATTACHMENT BOLT TO LOOSED AND SUBSEQUENTLY FATIGUE AND BREAK. THE BOLT BREAKAGE CAN CAUSE THE LEFT HAND CONTROL ARM TO SEPARATE FROM THE FRAME.

Consequence: IF THIS OCCURS, A LOSS OF VEHICLE CONTROL AND A CRASH COULD RESULT.

Remedy: DEALERS WILL TIGHTEN THE LEFT-HAND LOWER CONTROL ARM TO FRAME REAR NUT TO THE PROPER TORQUE SPECIFICATION.

Reported: 1994-10-26 (October 26, 1994)

THE WINDSHIELDS WERE INSTALLED WITH INCORRECT WINDSHIELD OPENING PINCH-WELD-FLANGE PRIMER. THIS PRIMER WILL NOT PROPERLY ETCH THE PAINTED SURFACE OF THE FLANGE, ALLOWING THE WINDSHIELD TO SEPARATE FROM THE VEHICLE DURING A COLLISION. THIS DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 212, "WINDSHIELD MOUNTING."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: THE SEPARATION OF THE WINDSHIELD FROM THE VEHICLE DURING COLLISION INCREASES THE RISK OF INJURY FOR ALL PERSONS INVOLVED.

Remedy: DEALERS WILL REMOVE THE WINDSHIELD AND REINSTALL IT USING THE CORRECT PRIMER.

Reported: 1995-12-13 (December 13, 1995)

IF BOTH THE LAP-BELT AND SHOULDER-BELT ENERGY MANAGEMENT LOOPS ON THE FRONT SEAT BELT ASSEMBLIES RELEASE AT OR NEAR THE SAME TIME, ACCELERATION FORCES CAN CAUSE THE BUCKLE RELEASE MECHANISM TO ACTIVATE AND ALLOW THE BUCKLE TO SEPARATE FROM THE LATCH.

Consequence: IF THE BUCKLE RELEASED, THE SYSTEM WOULD FAIL TO PROVIDE ADEQUATE OCCUPANT RESTRAINT PROTECTION.

Remedy: DEALERS WILL REMOVE THE STITCHING THAT CREATES THE ENERGY MANAGEMENT LOOP IN THE SHOULDER BELT(S).

Reported: 1995-12-13 (December 13, 1995)

THESE VEHICLES WERE BUILT WITH FRONT SEAT BELT SYSTEMS WITH NO ENERGY MANAGEMENT LOOPS AND MAY NOT MEET THE HEAD INJURY CRITERIA REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Consequence: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANTS OF THESE SEATS MAY NOT BE PROPERLY RESTRAINED.

Remedy: DEALERS WILL REPLACE THE RETRACTOR PORTION OF THE SEAT BELT ASSEMBLY(S) WITH ONE HAVING THE NEWLY DESIGNED ENERGY-MANAGEMENT TWIN-LOOP SYSTEM.

Reported: 1995-12-21 (December 21, 1995)

THE SEAT RECLINER TO SEAT FRAME ATTACHING BOLTS ON THESE VEHICLE COULD LOOSEN, FATIGUE AND FRACTURE, ALLOWING THE SEAT BACK TO SUDDENLY RECLINE.

Consequence: IF THIS WERE TO OCCUR TO THE DRIVER'S SEAT, THIS COULD RESULT IN A SUDDEN LOSS OF VEHICLE CONTROL INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REMOVE ALL FOAM AND/OR FABRIC SANDWICHED BETWEEN THE RECLINER ASSEMBLY AND THE SEAT FRAME, INSTALL WASHERS BETWEEN THE SEAT RECLINER AND THE SEAT FRAME AT EACH ATTACHMENT POINT, AND INSTALL NEW ATTACHING BOLTS TORQUED TO A HIGHER SPECIFICATION. THESE CORRECTIONS WILL BE MADE TO BOTH THE DRIVER'S AND PASSENGER'S SEATS.

Reported: 1998-07-01 (July 1, 1998)

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.

Consequence: THIS CONDITION CAN RESULT IN INOPERATIVE WIPERS, REDUCING A DRIVER'S VISIBILITY, AND INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER.

Reported: 1999-02-05 (February 5, 1999)

VEHICLE DESCRIPTION: PICKUP TRUCKS, CREW CABS, UTILITY TRUCKS AND SPORT UTILITY VEHICLES. THESE VEHICLES WERE BUILT WITH THE POLARITY OF THE WIRING FOR THE ZERO ADJUST BRAKE SWITCH REVERSED FROM WHAT WAS SPECIFIED ON THE SWITCH DRAWING. WITH THE REVERSED POLARITY, THE CONTACTS IN THE BRAKE SWITCH CAN WEAR OUT PREMATURELY. THE BRAKE SWITCH WILL PERFORM NORMALLY UNTIL THE BRAKE SWITCH CONTACTS WEAR OUT, RESULTING IN LOSS OF THE BRAKE LAMPS WITHOUT ANY WARNING TO THE DRIVER.

Consequence: THIS WOULD FAIL TO WARN A FOLLOWING DRIVER THAT THE VEHICLE IS BRAKING AND COULD LEAD TO A CRASH.

Remedy: DEALERS WILL REPLACE THE BRAKE SWITCH AND REVERSE THE WIRING.