Isuzu HOMBRE recalls by model year

Reported: 2003-06-02 (June 2, 2003) · Model years: 1996, 1997

ON CERTAIN PICKUP TRUCKS WITH CERTAIN MODEL-ENGINE COMBINATIONS, THE WINDSHIELD WIPER MOTOR MAY FAIL DUE TO CRACKED SOLDER JOINTS ON THE CONTROLLER CIRCUIT BOARD. THE WINDSHIELD WIPERS COULD WORK INTERMITTENTLY OR NOT AT ALL.

Consequence: IF THIS WERE TO OCCUR DURING BAD WEATHER, DRIVER VISIBILITY WOULD BE REDUCED, WHICH COULD RESULT IN A CRASH.

Remedy: DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER. OWNER NOTIFICATION BEGAN JULY 14, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT ISUZU AT 1-800-255-6727.

Reported: 1996-04-03 (April 3, 1996) · Model years: 1996

A BRAZILIAN DOMESTIC HEADLAMP WAS INADVERTENTLY INSTALLED ON THESE VEHICLES INSTEAD OF THE REQUIRED U.S. DOMESTIC ASSEMBLY. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: REDUCED LIGHTING FROM THESE HEAD LAMPS CAN CAUSE A VISIBILITY PROBLEM INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL INSPECT BOTH THE LEFT AND RIGHT HEAD LAMP ASSEMBLIES FOR PRESENCE OF THE AIMING PADS. IF THE HEAD LAMP ASSEMBLY DOES NOTE HAVE THESE AIMING PADS, IT WILL BE REPLACED WITH THE CORRECT HEAD LAMP ASSEMBLY.

Reported: 1997-01-29 (January 29, 1997) · Model years: 1996

THE TOP COAT PAINT SEVERELY PEELS DUE TO OVERBAKING OF THE POWDER PRIMER PRIOR TO THE TOP COAT APPLICATION. SINCE THE WINDSHIELD PRIMER AND ADHESIVE ADHERE TO THE TOP COAT PAINT ONTHE WINDSHIELD OPENING FLANGE, THE WINDSHIELD DOES NOT COMPLY WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 212, "WINDSHIELD MOUNTING."

Consequence: IN THE EVENT OF A VEHICLE CRASH, THE WINDSHIELD MAY NOT STAY IN PLACE AS REQUIRED BY FMVSS NO. 212.

Remedy: ALL VEHICLES HAVE BEEN REPURCHASED. THIS CAMPAIGN IS 100%.

Reported: 1998-07-01 (July 1, 1998) · Model years: 1996

VEHICLE DESCRIPTION: SPORT UTILITY VEHICLES, 2 AND 4-WHEEL DRIVE. SOLDER JOINTS NEAR THE WIRING HARNESS CONNECTOR CAN CRACK CAUSING THE WINDSHIELD WIPERS TO WORK INTERMITTENTLY.

Consequence: THIS CONDITION CAN RESULT IN INOPERATIVE WIPERS, REDUCING A DRIVER'S VISIBILITY, AND INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL REPLACE THE WIPER MOTOR CIRCUIT BOARD AND COVER.

Reported: 1997-06-12 (June 12, 1997) · Model years: 1997

VEHICLE DESCRIPTION: EXTENDED CAB PICKUP TRUCKS EQUIPPED WITH 60/40 FRONT BENCH SEATS AND EXTENDED CAB PICKUP TRUCKS AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH MANUAL LOCKING RECLINER BUCKET SEATS. THE OUTBOARD SAFETY BELT WEBBING ON THE DRIVER'S AND/OR PASSENGER'S SEAT CAN SEPARATE DURING A FRONTAL IMPACT.

Consequence: IF A SEPARATION OCCURRED AND THERE WERE SECONDARY CRASH EVENTS OR VEHICLE ROLLOVER, THERE WOULD BE NO BELT RESTRAINT OF THE OCCUPANT AND INCREASED INJURIES COULD OCCUR.

Remedy: DEALERS WILL INSTALL A PROTECTIVE COVER OVER THE RECLINER MECHANISM.

Reported: 1997-09-11 (September 11, 1997) · Model years: 1997

VEHICLE DESCRIPTION: LIGHT DUTY PASSENGER PICKUP TRUCKS EQUIPPED WITH 4.3L ENGINES. THE FRONT BRAKE LINE CAN CONTACT THE LEFT-HAND SIDE OF THE ENGINE OIL PAN CAUSING THE BRAKE LINE TO WEAR TO THE POINT OF BRAKE FLUID LOSS DURING BRAKE APPLICATION.

Consequence: BRAKE FLUID LOSS CAN REDUCE BRAKING EFFECTIVENESS AND INCREASE STOPPING DISTANCES RESULTING IN A VEHICLE CRASH WITHOUT PRIOR WARNING.

Remedy: DEALERS WILL INSPECT THE CLEARANCE BETWEEN THE OIL PAN AND THE BRAKE LINE. IF THE CLEARANCE IS 6MM OR LESS, DEALERS WILL INSTALL AN ADDITIONAL BRAKE LINE CLIP AND IF THERE WAS CONTACT BETWEEN THE OIL PAN AND BRAKE LINE, THE FRONT BRAKE LINE WILL BE REPLACED.

Reported: 1997-11-25 (November 25, 1997) · Model years: 1998

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND MULTI-PURPOSE VEHICLES. AN ENGINE ELECTRICAL WIRING-HARNESS CLIP CAN MELT AND DRIP ONTO THE EXHAUST MANIFOLD.

Consequence: THE CLIP MATERIAL ON THE EXHAUST MANIFOLD CAN IGNITE AND SUBSEQUENTLY IGNITE OTHER COMBUSTIBLE COMPONENTS RESULTING IN A VEHICLE FIRE.

Remedy: DEALERS ARE CONTACTING OWNERS BY TELEPHONE TO HAVE THEIR VEHICLES TOWED TO THE DEALER AND ALTERNATE TRANSPORTATION PROVIDED TO THEM UNTIL THE DEALER CAN REROUTE THE ELECTRICAL WIRING-HARNESS.

Reported: 2000-09-08 (September 8, 2000) · Model years: 2000

VEHICLE DESCRIPTION: LIGHT DUTY PICKUP TRUCKS AND SPORT UTILITY VEHICLES. SOME OF THESE VEHICLES WERE BUILT WITH INCORRECT PAYLOAD INFORMATION ON THE VEHICLE CERTIFICATION LABEL. THE PAYLOAD SHOWN ON THE LABEL IS GREATER THAN THE MAXIMUM VALIDATED PAYLOAD. IF THE VEHICLE WERE LOADED TO THE INCORRECTLY LABELED PAYLOAD, IT MAY NOT RIDE AND HANDLE IN THE MANNER THAT THE DRIVER EXPECTS.

Consequence: THIS COULD RESULT IN A LOSS OF CONTROL OF THE VEHICLE OR AN INABILITY TO STOP THE VEHICLE WITHIN EXPECTED STOPPING DISTANCES.

Remedy: OWNERS WILL BE SENT A NEW LABEL FOR INSTALLATION ON THE DRIVER'S DOOR OF THE VEHICLE.