Volkswagen CORRADO recalls by model year

Reported: 1992-04-14 (April 14, 1992) · Model years: 1989, 1990, 1991, 1992

THE FUEL HOSE ATTACHED TO THE FUEL DISTRIBUTION RAIL ON THE ENGINE MAY SHRINK BEYOND THE CLAMP FORCE OF THE FUEL HOSE CLAMPS, ALLOWING FUEL TO LEAK.

Consequence: FUEL LEAKAGE IN THE ENGINE COMPARTMENT CAN CAUSE AN UNDERHOOD FIRE IF THE FUEL COMES IN CONTACT WITH A SOURCE OF IGNITION.

Remedy: REPLACE THE FUEL HOSE ATTACHED TO THE FUEL RAIL AND INSTALL A NEW SPRING TYPE SELF-TIGHTENING CLAMP.

Reported: 1996-07-01 (July 1, 1996) · Model years: 1989, 1990

IN THE EVENT THE ENGINE OVERHEATS AND THE VEHICLE IS OPERATED CONTINUOUSLY IN THAT CONDITION, THE COOLANT PRESSURE WILL RISE TO A LEVEL AT WHICH THE HEAT EXCHANGER COULD LEAK.

Consequence: A LEAKING HEAT EXCHANGER WILL ALLOW HOT COOLANT TO ESCAPE CAUSING INJURY TO THE DRIVER'S FEET OR COULD STEAM UP THE INTERIOR OF THE VEHICLE TEMPORARILY IMPAIRING THE DRIVER'S VISIBILITY, INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE THE HEAT EXCHANGER ON THESE VEHICLES.

Reported: 1991-04-22 (April 22, 1991) · Model years: 1990, 1991

THE FUEL FILTER HOUSING, WHICH SERVES AS THE BASE FOR THE FUEL PUMP (LOCATED IN THE FUEL TANK) COULD DEFORM, RESULTING IN THE FUEL PUMP BECOMING LOOSE.

Consequence: A LOOSE AND IMPROPERLY SEATED FUEL PUMP CAN CAUSEREDUCED FUEL FLOW TO THE ENGINE RESULTING IN POSSIBLE DRIVABILITY PROBLEMS ANDSTALLING OF THE VEHICLE.

Remedy: REPLACE FUEL FILTER.

Reported: 1993-06-14 (June 14, 1993) · Model years: 1992, 1993

AN ENGINE COMPARTMENT ELECTRICAL WIRING HARNESS MAY HAVE BEEN ROUTED TOO CLOSE TO A SHEET METAL EDGE. THE WIRING CAN BECOME DAMAGED DURING NORMAL VEHICLE OPERATION DUE TO CHAFING, RESULTING IN AN ELECTRICAL SHORT.

Consequence: IF A SHORT OCCURS, EITHER THE ENGINE COULD STALL ORTHE RADIATOR FAN COULD STOP OPERATING CAUSING THE ENGINE TO OVERHEAT. EITHERCONDITION COULD RESULT IN A VEHICLE ACCIDENT.

Remedy: REROUTE AND SECURE VARIOUS WIRING HARNESSES INSIDE THE ENGINE COMPARTMENT.

Reported: 1998-11-13 (November 13, 1998) · Model years: 1992, 1993, 1994

VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH VR6 ENGINES. A COOLANT SYSTEM COMPONENT SUCH AS THE THERMO SWITCH, RADIATOR FAN, OR WATER PUMP, CAN MALFUNCTION CAUSING THE COOLANT TEMPERATURE AND COOLANT SYSTEM PRESSURE TO INCREASE SIGNIFICANTLY. OVER TIME, EXCESSIVE PRESSURE CAN CAUSE LEAKAGE OF COOLANT FROMTHE SYSTEM, INCLUDING LEAKAGE FROM THE HEAT EXCHANGER.

Consequence: LEAKAGE OF HOT COOLANT FROM THE HEAT EXCHANGER CAN CAUSE INJURY TO THE FEET OF THE DRIVER OR STEAM UP THE INTERIOR OF THE VEHICLE TEMPORARILY IMPAIRING THE DRIVER'S VISION.

Remedy: DEALERS WILL INSTALL IN THE COOLANT INLET HOSE TO THE HEATER CORE, A PRESSURE REDUCER WITH A 5MM DIAMETER SECURED BY A SPRING TENSIONED HOSE CLAMP. ALSO A NEW RELAY THAT WILL CHANGE THE OPERATION OF THE SECONDARY ELECTRICAL COOLANT PUMP WILL BE INSTALLED. DEALERS WILL ALSO PERFORM A FUNCTIONAL CHECK OF THE COOLING SYSTEM TO MAKE SURE THAT ALL COOLING SYSTEM COMPONENTS OPERATE PROPERLY.

Reported: 1995-09-20 (September 20, 1995) · Model years: 1993, 1994, 1995

IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.

Consequence: A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.