1994 Saab 900: complaints, problems and recalls

WHILE DRIVING THE VEHICLE LOST ALL POWER. THE VEHICLE WAS SENT TO THE DEALERSHIP WHO FOUND A BUNDLE OF WIRES HELD TOGETHER BY A PLASTIC BINDER WIRE CLIP. THE BUNDLE BECAME LOOSE AND A WIRE WAS EXPOSED TO AND RUBBING ON METAL. *NLM

Owner-reported narrative. Look up ODI 10012206 at NHTSA ↗

VEHICLE STALLED IN TRAFFIC DUE TO ENGINE FAILURE.*MR THE GASKET SURROUNDING THE TIMING BELT COVER BECAME TANGLED WITH THE TIMING BELT WHICH CAUSED THE VEHICLE NOT TO START.*TS *JB

Owner-reported narrative. 90,837 miles reported. Look up ODI 10044446 at NHTSA ↗

IN JULY OF 2003, SAAB OF SANTA MONICA, CA REPLACED THE TIMING BELT ON MY USED 1994 SAAB 900 (65,000 MILE SERVICE). THE LABOR WAS COMPLIMENTARY AND COVERED UNDER A CHANGE IN SCHEDULED MAINTENANCE OUTLINED BY SAAB USA IN A LETTER SENT OUT TO SAAB 900 OWNERS IN JULY 1995. THE LETTER AMENDED INFORMATION IN THE WARRANTIES AND SERVICE RECORD BOOKLET AND OWNER'S MANUAL AND STATED THAT RATHER THAN EVERY 95,000 MILES, SAAB WAS NOW RECOMMENDING THAT THE BELT FOR THE CAMSHAFT DRIVE MECHANISM BE REPLACED BEGINNING WITH THE 35,000 MILE MAJOR SERVICE AND AT…

Owner-reported narrative. 72,000 miles reported. Look up ODI 10047020 at NHTSA ↗

WHILE DRIVING ON THE DAN RYAN EXPRESSWAY AT 3:00 P.M. ON 4/30/04, I HEARD A POP AND I THOUGHT A BELT SNAPPED, MY CAR, A 1994 SAAB S, JERKED, IT WAS DIFFICULT TO GAIN CONTROL. I SMELLED BURNING RUBBER. I LOOKED IN THE REAR VIEW MIRROR AND SAW A TIRE ROLE FROM EAST TO WEST ON THE EXPRESSWAY. I THOUGHT I RAN OVER IT. FURTHER DOWN THE ROAD A PERSON ON ANOTHER CAR TOLD ME I DIDN'T HAVE A TIRE ON THE PASSENGER SIDE OF THE CAR IN THE REAR. WHEN I PULLED OFF THE EXPRESSAY I SAW THE TIRE WAS MISSING. THE MIDDLE OF THE TIRE HAD PULLED AWAY FROM THE…

Owner-reported narrative. 78,000 miles reported. Look up ODI 10068185 at NHTSA ↗

THE EXPERIENCE LEAKING HEAD GASKET REPEATED PROBLEM. THE ENGINE OVERHEATING AND BRAKE PROBLEMS. *BF THE BRAKES SQUEALED WHEN STOPPING, THE WINDSHIELD WIPERS, THE PASSENGER DOOR WAS HARD TO CLOSE, THE BATTERY LIGHT HAD RUN BAD, THE HEAT OPERATION WAS INOPERATIVE, THERE WAS AN OIL LEAK, SEAT COVER LEFT LOWER CRACKED, FLUID LEAKED UNDER THE VEHICLE/OVERNIGHT COOLANT LEAK, OVER HEATING WHILE THE VEHICLE WAS IN MOTION, THE TURN SIGNAL ASSEMBLY, LEAKING DISTRIBUTOR SEAL, BROKEN TURN SIGNAL, AT A CERTAIN POSITION THE SEAT WOULD NOT OPERATE FORWAR…

Owner-reported narrative. Look up ODI 10101475 at NHTSA ↗

TL* THE CONTACT OWNS A 1994 SAAB 900. THE CONTACT STATED THAT THE FRONT DRIVER'S SEAT WAS CRACKED AND HAD A DAMAGED FRAME THAT WAS DETERIORATING. THE SEAT WAS NOT SECURED AND WOULD MOVE INDEPENDENTLY. THE FRONT PASSENGER SEAT ALSO EXHIBITED THE FAILURE. THE SRS SENSOR AND THE SERVICE ENGINE SENSOR ILLUMINATED FOR AN EXTENDED PERIOD OF TIME. THE VEHICLE WAS TAKEN TO AN AUTHORIZED DEALER BUT THE DEALER WAS UNABLE TO RESET THE CODES. THE CONTACT REFERENCED NHTSA CAMPAIGN ID NUMBER: 94V226000 (SEATS) HOWEVER, THE VEHICLE WAS NOT INCLUDED IN THE REC…

Owner-reported narrative. 22,601 miles reported. Look up ODI 10595542 at NHTSA ↗

INTERMITTENT STALLING 2 TIMES. *SD

Owner-reported narrative. Look up ODI 500831 at NHTSA ↗

VENTILATION SYSTEM WEAK, WINDOWS FOG UP, ALSO WHEN IN DEFORST MODE, DEFAULTS TO PANEL DISTRIBUTION DURING HEAVY ACCELERATION.

Owner-reported narrative. Look up ODI 503378 at NHTSA ↗

Reported: 1994-04-16 (April 16, 1994)

THE ORIGINAL FRONT BRAKE DISCS AND/OR PADS SHIELDS DO NOT PROTECT THE ASSEMBLIES FROM BEING COATED WITH A LAYER OF SLUSH, ROAD SALT OR WATER WHILE DRIVING IN SNOW OR HEAVY RAIN. THIS CAN RESULT IN A DELAY IN BRAKING ACTION THAT INCREASES NORMAL STOPPING DISTANCE.

Consequence: INCREASED STOPPING DISTANCE COULD RESULT IN AN ACCIDENT.

Remedy: DEALERS WILL REPLACE THE ORIGINAL FRONT BRAKE SHIELDS WITH A NEW DESIGN. AN ADDITIONAL HOLE WILL BE DRILLED IN THE STEERING KING PIN HOUSING TO ATTACH A LARGER COVER PLATE. A SMALLER PROTECTION PLATE WILL ALSO BE ATTACHED TO THE EXISTING TWO BOLTS IN THE HUB.

Reported: 1994-06-13 (June 13, 1994)

A WELD IN THE SEAT RAILS WAS NOT MADE, INCREASING THE RISK OF FATIGUE CRACKS FORMING AROUND THE ATTACHMENT BUSHINGS ON THE HEIGHT ADJUSTMENT MECHANISM, CAUSING THE POSSIBILITY OF THE HEIGHT ADJUSTER BREAKING IN A REAR END COLLISION AND ALLOWING THE SEAT TO FOLD BACKWARDS.

Consequence: THIS CAN INCREASE THE RISK OF INJURY TO SEAT OCCUPANTS.

Remedy: DEALERS WILL INSTALL NEW FRONT SEAT FRAME RAILS.

Reported: 1994-07-08 (July 8, 1994)

TWO TRIGGER SPRINGS MOUNTED TO THE FORE/AFT ADJUSTMENT LEVER DO NOT DEVELOP SUFFICIENT FORCE TO PROPERLY LOCK THE SEAT RAILS. AFTER THE SEAT IS ADJUSTED, THIS DOES NOT ALLOW THE SEAT RAIL LOCK TO PROPERLY ENGAGE, WHICH CAN CAUSE THE SEAT TO MOVE IN A SUDDEN STOP OR COLLISION.

Consequence: THIS CAN INCREASE THE POSSIBILITY OF INJURY TO A SEAT OCCUPANT IN THE EVENT OF A SUDDEN STOP OR ACCIDENT.

Remedy: DEALERS WILL REMOVE BOTH FRONT SEATS AND THE TWO SPRINGS ON EACH SEAT WILL BE REPLACED WITH NEW SPRINGS WITH PROPER TENSION TO ENSURE PROPER ENGAGEMENT.

Reported: 1994-09-14 (September 14, 1994)

THE TWO WELD POINTS IN THE REARWARD ATTACHMENT BRACKET FOR THE SIDE IMPACT PROTECTION BEAM IN THE REAR DOOR MAY BE OUT OF POSITION. IF THE WELDS ARE OUT OF POSITION, THE VEHICLES WILL NOT MEET THE REQUIREMENTS OF FMVSS 214, S5, "SIDE DOOR STRENGTH."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: PASSENGERS SITTING IN THE REAR SEATS WILL BE SUBJECT TO AN INCREASED RISK OF INJURY IN THE EVENT OF A SIDE COLLISION.

Remedy: DEALERS WILL INSTALL SUPPORT BRACKETS AT THE SUPPORT WELD LOCATIONS.

Reported: 1994-11-18 (November 18, 1994)

ONE OR MORE OF THE ARC WELDS CAN BE MISSING ON THE SEAT BACK FRAME RECLINER.

Consequence: THIS CAN RESULT IN A SEAT BACK FALLING BACKWARDS UNDER A LOAD.

Remedy: BOTH FRONT SEAT BACKS WILL BE INSPECTED WITH THE USE OF A HOOK TO PULL BACK THE SEAT BACK UPHOLSTERY. FOR ANY SEAT WITH MISSING WELDS, THE SEAT BACK FRAME/RECLINER WILL BE REPLACED.

Reported: 1995-03-29 (March 29, 1995)

IT IS POSSIBLE TO MOVE THE SHIFT LEVER INTO THE REVERSE GEAR POSITION, REMOVE THE IGNITION KEY, AND STILL HAVE THE TRANSMISSION IN NEUTRAL, OR, TO ACCIDENTLY DISENGAGE REVERSE BY STRIKING THE GEAR LEVER.

Consequence: IF THE PARKING BRAKE IS NOT APPLIED, THE CAR CAN ROLL FROM ITS ORIGINAL PARKED POSITION INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE TRANSMISSION LINKAGE COMPONENTS AND COMPLETE A SPECIALLY DEVELOPED SERVICE ADJUSTMENT PROCEDURE THAT WILL ENSURE THAT WHEN THE SHIFT IS MOVED TO THE REVERSE POSITION, THE REVERSE GEAR IS ACTUALLY ENGAGED.

Reported: 1997-03-21 (March 21, 1997)

CORROSION AROUND THE ZINC-COATED THROTTLE CONTROL LEVER BUSHING CAN CAUSE THE THROTTLE LEVER TO BIND.

Consequence: THIS BINDING CAN RESULT IN THE THROTTLE PLATE NOT RETURNING TO THE CLOSED POSITION WHEN THE THROTTLE PEDAL IS RELEASED AND A SUBSEQUENT LOSS OF THROTTLE CONTROL.

Remedy: DEALERS WILL REPLACE THE ZINC-COATED THROTTLE CONTROL LEVER BUSHING WITH A NICKEL-COATED BUSHING AND BOLT.

Reported: 1998-02-24 (February 24, 1998)

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE INSTRUCTIONS FOR PROPERLY AIMING THE HEADLIGHTING SYSTEM WERE OMITTED. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 108, "LAMPS, REFLECTIVE DEVICES, AND ASSOCIATED EQUIPMENT."

Consequence: IF THE HEADLAMP ASSEMBLIES ARE REPLACED, CUSTOMERS MAY NOT BE ABLE TO PROPERLY AIM THE HEADLIGHTS.

Remedy: OWNERS WILL BE SENT AIMING INSTRUCTIONS, AND DIRECTIONS FOR AFFIXING THESE INSERTS TO THE OWNER GUIDES. IF AN OWNER SO DESIRES, A DEALER CAN AFFIX THE INSERTS IN THEIR OWNER GUIDE FOR THEM.