2010 Medtec TYPE II (VAN): complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
2 distinct recall campaigns
Not available median reported failure mileage
Scope: 2010 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
2 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
10V511000 · Seat Belts
Reported: 2010-10-19 (October 19, 2010)
MEDTEC IS RECALLING CERTAIN MODEL YEAR 2007 THROUGH 2010 AMBULANCES MANUFACTURED FROM SEPTEMBER 14, 2007, THROUGH APRIL 15, 2010. THE REAR FACING AMBULANCE ATTENDANT SEAT WAS NOT EQUIPPED WITH A TYPE 2 SEAT BELT ASSEMBLY, AND SO THE VEHICLES FAIL TO COMFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 208, "OCCUPANT CRASH PROTECTION."
Consequence: USE OF AN IMPROPER SEAT BELT ASSEMBLY MAY INCREASE THE RISK OF INJURY TO THE SEAT OCCUPANT IN THE EVENT OF A CRASH.
Remedy: MEDTEC WILL NOTIFY OWNERS AND DEALERS WILL INSTALL A TYPE 2 SEAT BELT ASSEMBLY FREE OF CHARGE. THE SAFETY RECALL BEGAN ON DECEMBER 6, 2010. OWNERS MAY CONTACT MEDTEC TOLL-FREE AT 1-866-263-3832.
NHTSA campaign record ↗11V098000 · Seats
Reported: 2011-02-14 (February 14, 2011)
MEDTEC IS RECALLING CERTAIN MODEL YEAR 2010 AMBULANCE TYPE II VANS FOR NOT COMPLYING WITH FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 207, "SEATING SYSTEMS," AND FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 210, "SEAT BELT ASSEMBLY ANCHORAGES." THE REAR FACING AMBULANCE ATTENDANT SEAT UTILIZES A STEEL FLOOR REINFORCEMENT PLATE ON THE BOTTOM SIDE OF THE ALUMINUM FLOOR SUBSTRUCTURE AND THE REINFORCEMENT PLATE WAS OMITTED IN SOME AMBULANCE BODIES.
Consequence: IN THE EVENT OF A CRASH, THE SEAT BELT ASSEMBLY ANCHORAGE MAY DISCONNECT FROM THE FLOOR CAUSING THE ASSEMBLY TO FAIL TO RESTRAIN THE SEAT OCCUPANT INCREASING THE RISK OF INJURY TO THAT OCCUPANT.
Remedy: DEALERS WILL INSTALL THE MISSING REINFORCEMENT PLATE UNDER THE FLOOR SUBSTRUCTURE FREE OF CHARGE. THE RECALL IS EXPECTED TO BEGIN DURING MARCH 2011. OWNERS MAY CONTACT MEDTEC TOLL-FREE AT 1-866-263-3832.
NHTSA campaign record ↗