1977 Mack DMM: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
5 distinct recall campaigns
Not available median reported failure mileage
Scope: 1977 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
5 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
77V173000 · Engine And Engine Cooling:Cooling System:Fan
Reported: 1977-10-12 (October 12, 1977)
THE FLEX BLADE FANS ON THE INVOLVED VEHICLES MAY DEVELOP CRACKS IN THE LAMINATED STIFFENER AS A RESULT OF FATIGUE DURING OPERATION. IF SUCH A CONDITION EXISTS AND THE CRACKS GO UNDETECTED, CONTINUED OPERATION COULD CAUSE PIECES OF THE STIFFENER TO BREAK OFF.
Remedy: DEALER WILL REPLACE THE ORIGINAL FAN WITH A STEEL FIXED BLADE FAN, FREE OF CHARGE.
NHTSA campaign record ↗77V174000 · Seat Belts:Front:Anchorage
Reported: 1977-10-12 (October 12, 1977)
THE INVOLVED VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 209, "SEATBELT ASSEMBLIES". ALTHOUGH THE SEATBELTS IN QUESTION PERFORMED MARGINALLY WITH RESPECT TO THE 5000 LB. LOAD REQUIREMENT, ADDITIONAL TESTING CONFIRMED THAT THE ANCHOR COULD FAIL, ALLOWING EITHER THE ANCHOR TO SLIP OVER THE HOLD-DOWN NUT OR THE ANCHOR TO SEPARATE INTO TWO PIECES.
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE SEAT BELT ASSEMBLIES WITHOUT CHARGE TO OWNER.
NHTSA campaign record ↗78V172000 · Steering:Linkages:Knuckle:Spindle:Arm
Reported: 1978-08-08 (August 8, 1978)
THE EXISTING CROSS STEERING ARMS MAY HAVE INSUFFICIENT FATIGUE LIFE IN THE NECK AREA. THIS IS NEAR THE BOSS FOR THE CROSS STEERING TUBE BALL JOINT CONNECTION. FAILURE OF EITHER OF THE CROSS STEERING LEVERS COULD LEAD TO LOSS OF STEERING CONTROL OF THE RIGHT FRONT WHEEL.
Remedy: THE DEALER WILL INSPECT AND, IF NECESSARY, INSTALL CROSS STEERING ARMS OF IMPROVED DESIGN AND GREATER STRENGTH.
NHTSA campaign record ↗78V210000 · Service Brakes, Air:Antilock:Interconnecting Assembly(Wiring)
Reported: 1978-10-03 (October 3, 1978)
DELAYS OF UP TO ABOUT 2 SECONDS MAY EXIST IN THE BRAKE APPLICATION TIMES TO THE BRAKES ON THE BOGIE AXLES IN THE PRESENCE OF CERTAIN TYPES OF WHEEL SPEED SENSOR SIGNAL DISCONTINUITIES OR DISTORTIONS THAT MAY OCCUR AS A RESULT OF SENSOR WIRE FAILURE. THIS CONSTITUTES A NON-COMPLIANCE TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 121, "AIR BRAKE SYSTEMS".
Remedy: DEALER WILL INSTALL NEW WHEEL SPEED SENSORS THAT INCORPORATE IMPROVED WIRING AND THE PRESENT BOGIE ANTI-WHEEL LOCK SYSTEM WILL BE CHANGED TO AN AXLE-TO-AXLE SYSTEM FOR IMPROVED RELIABILITY.
NHTSA campaign record ↗79V133000 · Engine And Engine Cooling:Engine
Reported: 1979-05-31 (May 31, 1979)
IN THE EVENT OF TURBOCHARGER COMPRESSOR WHEEL FAILURE, ONE OR MORE OF THE FOUR CAPSCREWS THAT HOLD THE TURBOCHARGER TOGETHER MAY BE STRUCK BY PARTS OF THE COMPRESSOR WHEEL, RESULTING IN THE CAPSCREWS BEING DAMAGED. IF THESE CAPSCREWS ARE DAMAGED TO THE POINT THAT THEY ALLOW THE COMPRESSOR BACK PLATE TO DISLOCATE FROM THE TURBOCHARGER BEARING HOUSING, ENGINE LUBRICATING OIL MAY BE ALLOWED TO ESCAPE UNDER PRESSURE, CONTACTING THE ENGINE EXHAUST MANIFOLD SECTIONS OR TURBOCHARGER TURBINE HOUSING.
Remedy: DEALER WILL INSTALL A SHIELD FOR THE HEADS OF THE FOUR CAPSCREWS, ALONG WITH STRONGER SAE 8 GRADE 8 CAPSCREWS, IF NECESSARY, AT NO COST TO OWNER.
NHTSA campaign record ↗