2006 Hino ND6J: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
2 distinct recall campaigns
Not available median reported failure mileage
Scope: 2006 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
2 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
05V356000 · Suspension:Front:Wheel Bearing
Reported: 2005-08-10 (August 10, 2005)
ON CERTAIN CHASSIS AND CABS, THE WHEEL BEARINGS WERE OIL-PACKED ONTO THE FRONT AXLE RATHER THAN GREASE LUBRICATED AS SPECIFIED. IT WAS LATER DETERMINED THAT THE CALIPER MOUNTING BOLTS WERE NOT PROPERLY TORQUED AND THE PROPER END PLAY ADJUSTMENT WAS NOT MADE.
Consequence: THIS CAN CAUSE THE CALIPER MOUNTING BOLTS TO BECOME LOOSE AND BACK OUT. THE CALIPER COULD BECOME DISCONNECTED FROM THE ROTOR ASSEMBLY WHICH WOULD CAUSE A DECREASE IN BRAKING ABILITY, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL TORQUE ALL AFFECTED CALIPER MOUNTING BOLTS AND READJUST EACH WHEEL FOR THE PROPER END PLAY ADJUSTMENT. THE RECALL BEGAN ON SEPTEMBER 6, 2005. OWNERS SHOULD CONTACT HINO AT 248-648-6400.
NHTSA campaign record ↗06V169000 · Steering:Linkages
Reported: 2006-05-18 (May 18, 2006)
ON CERTAIN TRUCKS, DURING ASSEMBLY, THE DRAG LINK ATTACHMENT NUTS AT THE PITMAN ARM AND STEERING ARM MAY HAVE BEEN INCORRECTLY TORQUED. RESIDUAL GREASE AND PAINT WHICH WAS APPLIED AS A RUST INHIBITOR ON THE STEERING ARM MAY HAVE CONTRIBUTED TO A LOSS OF TORQUE AFTER ASSEMBLY.
Consequence: INCREASED WEAR FOR THE DRAGLINK CONNECTIONS CAN OCCUR CREATING A NOTICEABLE INCREASE IN THE AMOUNT OF STEERING WHEEL FREE PLAY. IF THIS CONDITION WAS IGNORED, A LOSS OF STEERING CONTROL OF THE VEHICLE COULD OCCUR WHICH COULD RESULT IN A CRASH.
Remedy: DEALERS WILL INSPECT THE STEERING ARM TIGHTNESS AND REMOVE ALL GREASE AND PAINT FROM THE STEERING ARMS AND RETORQUE THE DRAGLINK ATTACHMENT NUTS AT THE STEERING ARM AND PITMAN ARM. THE RECALL BEGAN ON MAY 12, 2006. OWNERS MAY CONTACT HINO AT 1-248-648-6430.
NHTSA campaign record ↗