2006 Freightliner CENTURY ST: complaints, problems and recalls

TL*THE CONTACT OWNS A 2006 FREIGHTLINER CENTURY ST. THE CONTACT STATED THAT THE VEHICLE WOULD NOT PASS INSPECTION BECAUSE THE S-CAM WAS FROZEN. THERE HAVE BEEN NO FAILURES TO DATE. THE VIN, ENGINE SIZE, AND NUMBER OF CYLINDERS WERE UNKNOWN. THE CURRENT MILEAGE WAS 21,763.

Owner-reported narrative. Look up ODI 10197819 at NHTSA ↗

Reported: 2007-07-03 (July 3, 2007)

CERTAIN FREIGHTLINER SCHOOL BUSES AND TRUCKS MANUFACTURED FROM OCTOBER 23, 2004, TO MARCH 21, 2006. DURING THE STEERING COLUMN MANUFACTURING PROCESS TWO WELDS MAY HAVE BEEN MISSING.

Consequence: COLUMNS WITH TWO WELDS MISSING MAY FATIGUE AND FRACTURE AND ALLOW THE STEERING WHEEL TO PROGRESSIVELY BE MOVED OUT OF ITS NORMAL POSITION WHICH MAY CAUSE THE STEERING TO RESPOND DIFFERENTLY THAN EXPECTED. IF THIS CONDITION IS IGNORED, A CRASH MAY OCCUR.

Remedy: FREIGHTLINER WILL NOTIFY OWNERS AND INSPECT AND REPAIR THE AFFECTED VEHICLE FREE OF CHARGE. THE RECALL BEGAN ON AUGUST 30, 2007. OWNERS CAN CONTACT FREIGHTLINER AT 1-800-547-0712.

Reported: 2007-07-16 (July 16, 2007)

CERTAIN FREIGHTLINER SCHOOL BUS CHASSIS, HEAVY TRUCKS, AND THOMAS BUILT SCHOOL BUSES MANUFACTURED BETWEEN JULY 2002 AND JULY 3, 2007, EQUIPPED WITH BENDIX SR-7 SPRING BRAKE CONTROL VALVES. THE PARKER SCV BRASS 90 DEGREE SINGLE CHECK VALVES (SCV) WHICH ATTACH TO THE SUPPLY PORT OF A BENDIX SR-7 SPRING BRAKE MODULATING VALVE CAN BREAK APART. PIECES OF THE PARKER SCV CAN BECOME LODGED INSIDE THE SR-7 SPRING BRAKE MODULATING VALVE, POTENTIALLY CAUSING EITHER LEAKAGE OUT OF THE SR-7 VALVE OR PREVENTING AIR FROM PROPERLY EXHAUSTING FROM THE SR-7 VALVE. ALSO, DUE TO A MANUFACTURING DEFECT IN THE INTERNAL RUBBER CHECK VALVE INSIDE THE SR-7 SPRING BRAKE MODULATING VALVES, THE VALVES CAN BECOME DEFORMED AND NOT SEAT PROPERLY.

Consequence: THESE CONDITIONS COULD EITHER RESULT IN LEAKAGE AND CAUSE A DELAY IN THE APPLICATION OF THE SPRING BRAKE WITHOUT WARNING OR POSSIBLY LEAD TO UNINTENDED VEHICLE ROLLAWAY OR BRAKE DRAG WHICH COULD RESULT IN A VEHICLE CRASH, PERSONAL INJURY, OR DEATH.

Remedy: FREIGHTLINER WILL NOTIFY OWNERS AND REPAIR THE VEHICLES FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 11, 2008 TO FREIGHTLINER, STERLING, AND FREIGHTLINER CUSTOM CHASSIS OWNERS; TO THOMAS BUILT BUS OWNERS ON FEBRUARY 1, 2008. OWNERS CAN CONTACT FREIGHTLINER AT 1-800-547-0712.

Reported: 2007-09-05 (September 5, 2007)

ON CERTAIN TRUCKS EQUIPPED WITH RACK AND PINION STEERING, THE TIE ROD ARMS MAY HAVE BEEN INCORRECTLY INSTALLED. THE THREADED END OF THE BALL SOCKET ASSEMBLY MAY FRACTURE AND SEPARATE.

Consequence: A FRACTURED TIE ROD ASSEMBLY WILL MAKE THE VEHICLE MORE DIFFICULT TO CONTROL AT HIGHER SPEEDS AND A CRASH MAY OCCUR.

Remedy: DEALERS WILL INSPECT FOR INSTALLATION OF THE STEERING ARMS. STEERING COMPONENTS WILL BE REPLACED ON TRUCKS THAT HAVE INCORRECTLY INSTALLED TIE ROD ARMS. THE RECALL BEGAN ON MAY 1, 2008. OWNER MAY CONTACT FREIGHTLINER AT 1-800-547-0712.

Reported: 2007-09-06 (September 6, 2007)

ON CERTAIN TRUCKS EQUIPPED WITH RACK AND PINION STEERING, THE BALL SOCKET ASSEMBLY AT THE INNER END OF THE DRIVER SIDE TIE ROD MAY BE DAMAGED IN A SHARP TURN. EXCESSIVE TIE ROD ANGLES MAY LOOSEN THE TIE ROD IN THE BALL SOCKET OR DAMAGE THE THREADED TIE ROD SOCKET ATTACHMENT TO THE STEERING RACK ON THE DRIVER SIDE. THE THREADED END OF THE BALL SOCKET ASSEMBLY MAY FRACTURE AND SEPARATE.

Consequence: A FRACTURED TIE ROD ASSEMBLY WILL MAKE THE VEHICLE MORE DIFFICULT TO CONTROL AT HIGHER SPEEDS AND A CRASH MAY OCCUR.

Remedy: DEALERS WILL CHANGE THE FRONT AXLE STEERING STOPS TO PREVENT INTERFERENCE IN THE TIE ROD BALL SOCKET ASSEMBLY AND STEERING COMPONENTS WILL BE REPLACED FREE OF CHARGE. THE RECALL BEGAN ON JULY 8, 2008, AND WILL BE MAILED IN PHASES THROUGH DECEMBER 31, 2008. OWNERS MAY CONTACT FREIGHTLINER AT 1-800-547-0712.

Reported: 2007-11-13 (November 13, 2007)

ON CERTAIN TRUCK-TRACTORS EQUIPPED WITH HOLLAND SIMPLEX SE OR SE II FIFTH WHEELS, THE LATCH LEVER PIVOT BOLT ASSEMBLY MAY HAVE BEEN OVER-TIGHTENED WHICH COULD DISTORT THE PIVOT BOLT SPACER SLEEVE. CORROSION OR CONTAMINATES IN THE PIVOT MAY CAUSE IT TO BIND AND PREVENT THE FIFTH WHEEL JAW FROM LATCHING SECURELY AROUND THE TRAILER KING PIN.

Consequence: THERE IS A POSSIBILITY THAT THE FIFTH WHEEL MAY FAIL TO LATCH WITHOUT THE DRIVER'S KNOWLEDGE. WHEN THE OCCURS, THE DRIVER COULD DRIVE AWAY AND THE TRAILER COULD BECOME DISENGAGED INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPLACE THE PIVOT BOLT AND SLEEVE WITH A HEX HEAD SHOULDER BOLT AND WASHER. THE RECALL BEGAN ON JANUARY 3, 2008. OWNERS MAY CONTACT FREIGHTLINER AT 1-800-547-0712.