1993 Chevrolet K30: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
3 distinct recall campaigns
Not available median reported failure mileage
Scope: 1993 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
3 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
93V016000 · Power Train:Automatic Transmission
Reported: 1993-02-01 (February 1, 1993)
UNANTICIPATED HEAT IN THE TRANSMISSION CAN FORCE THE TRANSMISSION FLUID OUT OF THE VENT TUBE.
Consequence: THE VENTED TRANSMISSION FLUID CAN CATCH FIRE IF EXPOSEDTO A SOURCE OF IGNITION.
Remedy: INSTALL A LONGER TRANSMISSION VENT HOSE ROUTED TO THE LEFT SIDE OF THE ENGINE COMPARTMENT OF THE VEHICLE.
NHTSA campaign record ↗93V163000 · Seats:Mid/Rear Assembly
Reported: 1993-09-27 (September 27, 1993)
THE REAR BENCH SEAT DOES NOT MEET THE LOAD REQUIREMENTS OF FMVSS 207, "SEATING SYSTEMS," BECAUSE THE MANUAL LATCH MECHANISM ON THE FOLDING FULL BENCH REAR SEAT WAS ATTACHED TO THE BACK FRAME LOWER CROSS TUBE WITH DOMED HEAD STEEL RIVETS INSTEAD OF THE BOLTS SPECIFIED.
Remedy: THE RIVETS MUST BE REPLACED WITH THE CORRECT BOLTS.
NHTSA campaign record ↗95V246000 · Seats
Reported: 1995-12-21 (December 21, 1995)
THE SEAT RECLINER TO SEAT FRAME ATTACHING BOLTS ON THESE VEHICLE COULD LOOSEN, FATIGUE AND FRACTURE, ALLOWING THE SEAT BACK TO SUDDENLY RECLINE.
Consequence: IF THIS WERE TO OCCUR TO THE DRIVER'S SEAT, THIS COULD RESULT IN A SUDDEN LOSS OF VEHICLE CONTROL INCREASING THE RISK OF A VEHICLE ACCIDENT.
Remedy: DEALERS WILL REMOVE ALL FOAM AND/OR FABRIC SANDWICHED BETWEEN THE RECLINER ASSEMBLY AND THE SEAT FRAME, INSTALL WASHERS BETWEEN THE SEAT RECLINER AND THE SEAT FRAME AT EACH ATTACHMENT POINT, AND INSTALL NEW ATTACHING BOLTS TORQUED TO A HIGHER SPECIFICATION. THESE CORRECTIONS WILL BE MADE TO BOTH THE DRIVER'S AND PASSENGER'S SEATS.
NHTSA campaign record ↗