1995 Chevrolet C30: complaints, problems and recalls

THE VAN WAS IN AN ACCIDENT. DUE TO THE IMPACT OF THE HIT, AND THE FACT THAT THE VAN IS NOT SUITABLE PER FDA REQUIREMENTS FOR A CAR SEAT. I HAD TO INSTALL A SEAT FROM ANOTHER SUV IN ORDER FOR THE CAR SEAT TO BE INSTALLED. THIS WAS MY ONLY VEHICLE AND THE FACT THAT THERE WAS NO OPTION FOR A SAFE INFANT CAR SEAT IS UNACCEPTABLE. I WAS HIT BY A DRIVER THAT CAUSED MAJOR IMPACT AND COULD HAVE RESULTED IN DEATH DUE TO SAFETY CONCERNS.

Owner-reported narrative. 70,000 miles reported. Look up ODI 11376787 at NHTSA ↗

WHILE APPLYING BRAKES VEHICLE DOES NOT RESPOND TO A COMPLETE STOP, VEHICLE SKIDS FORWARD.*AK WHEN APPROACHING A TRAFFIC STOP ON A ROUGH ROAD SURFACE BRAKES WILL APPLY FOR A FRCTION OF A SECOND THEN RELEASE, VEHICLE WILL THEN COAST WOTH NO BRAKES AND COAST THROUGH TRAFFIC. *MJ

Owner-reported narrative. Look up ODI 8002898 at NHTSA ↗

THE BRAKE PEDAL IS HARD WHEN APPLIED. A DELAY IS EXPERIENCED.*AK

Owner-reported narrative. Look up ODI 800878 at NHTSA ↗

ABS, BRAKE FAILURE, REPLACEMENT OF DIFFERENTIAL VALVE, WHEN BRAKES ARE APPLIED LOCKS UP IN FRONT AND EXTENDED STOPPING IN REAR. *AK

Owner-reported narrative. Look up ODI 802210 at NHTSA ↗

WHILE TRAVELING ABOUT 15-20MPH AND AFTER THE BRAKES ARE DEPRESSED THERE IS AN INITIAL RESPONSE, BUT VEHICLE CONTINUES TO GO FORWARD. NO ACCIDENTS OR INJURIES HAVE OCCURRED. *AK

Owner-reported narrative. Look up ODI 876651 at NHTSA ↗

Reported: 1995-02-16 (February 16, 1995)

DUE TO A THIN CASE CASTING, AN EXTERNAL TRANSMISSION LEAK CAN OCCUR.

Consequence: THIS CONDITION CAN CAUSE TRANSMISSION OIL TO SPRAYONTO THE EXHAUST SYSTEM AND RESULT IN A POSSIBLE VEHICLE FIRE.

Remedy: DEALERS WILL INSPECT THE TRANSMISSION CASE ASSEMBLY FOR THE INVOLVED CASE CASTING. IF THE ASSEMBLY IS INVOLVED, THE TRANSMISSION WILL BE REPLACED.

Reported: 1995-12-13 (December 13, 1995)

IF BOTH THE LAP-BELT AND SHOULDER-BELT ENERGY MANAGEMENT LOOPS ON THE FRONT SEAT BELT ASSEMBLIES RELEASE AT OR NEAR THE SAME TIME, ACCELERATION FORCES CAN CAUSE THE BUCKLE RELEASE MECHANISM TO ACTIVATE AND ALLOW THE BUCKLE TO SEPARATE FROM THE LATCH.

Consequence: IF THE BUCKLE RELEASED, THE SYSTEM WOULD FAIL TO PROVIDE ADEQUATE OCCUPANT RESTRAINT PROTECTION.

Remedy: DEALERS WILL REMOVE THE STITCHING THAT CREATES THE ENERGY MANAGEMENT LOOP IN THE SHOULDER BELT(S).

Reported: 1995-12-13 (December 13, 1995)

THESE VEHICLES WERE BUILT WITH FRONT SEAT BELT SYSTEMS WITH NO ENERGY MANAGEMENT LOOPS AND MAY NOT MEET THE HEAD INJURY CRITERIA REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Consequence: IN THE EVENT OF A VEHICLE CRASH, THE OCCUPANTS OF THESE SEATS MAY NOT BE PROPERLY RESTRAINED.

Remedy: DEALERS WILL REPLACE THE RETRACTOR PORTION OF THE SEAT BELT ASSEMBLY(S) WITH ONE HAVING THE NEWLY DESIGNED ENERGY-MANAGEMENT TWIN-LOOP SYSTEM.

Reported: 1996-01-02 (January 2, 1996)

THE STEERING COLUMN UPPER INTERMEDIATE-SHAFT NUT MAY NOT BE TORQUED TO PROPER SPECIFICATIONS. THE NUT COULD LOOSEN AND DETACH ALLOWING THE THROUGH-BOLT THAT SECURES THE UPPER INTERMEDIATE-SHAFT TO THE LOWER STEERING COLUMN SHAFT JOINT TO FALL OUT.

Consequence: THIS LOOSE ENGAGEMENT CAN PROVIDE NOTICEABLE NOISE AND ABNORMAL STEERING FEELING TO THE DRIVER AND, IF LEFT UNATTENDED, THE STEERING SHAFTS CAN SEPARATE RESULTING IN A LOSS OF STEERING CONTROL.

Remedy: DEALERS WILL TORQUE THE SUSPECT FASTENERS TO THE PROPER SPECIFICATIONS.

Reported: 1996-04-04 (April 4, 1996)

THESE VEHICLES WERE ASSEMBLED WITH THE THROTTLE CABLE CONTACTING THE DASH MAT WHICH COULD BIND THE THROTTLE. THIS DOES NOT MEET WITH THE MAXIMUM RETURN TIMES REQUIRED BY FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 124, "ACCELERATOR CONTROL SYSTEMS."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: THE ENGINE SPEED MAY NOT RETURN TO IDLE INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL INSPECT FOR ADEQUATE THROTTLE CABLE TO DASH MAT CLEARANCE, AND IF THERE IS INSUFFICIENT CLEARANCE, CUT OUT A PORTION OF THE DASH MAT TO PROVIDE PROPER CLEARANCE.

Reported: 1996-07-01 (July 1, 1996)

THESE TIRES HAVE BEAD DAMAGE WHICH OCCURED DURING TIRE MOUNTING.

Consequence: THIS DAMAGE TO THE TIRE REINFORCING STRUCTURE IN THE BEAD "TOE" AREA CAUSES A BULGE IN THE SIDEWALL AFTER THE TIRE IS INFLATED. THIS CONDITION WILL RESULT IN A SLOW AIR LOSS CAUSING THE TIRE TO GO FLAT. HOWEVER, IT IS POSSIBLE FOR THE DAMAGE TO RESULT IN A RAPID AIR LOSS CAUSING INJURIES TO ANYONE IF THEY WERE HANDLING THE TIRE WHEN THIS OCCURRED.

Remedy: DEALERS WILL DEMOUNT EACH TIRE AND INSPECT FOR BEAD DAMAGE. IF BEAD DAMAGE IS FOUND, THE TIRE WILL BE REPLACED.

Reported: 1997-03-07 (March 7, 1997)

VEHICLE DESCRIPTION: EXTENDED CAB AND 2-DOOR UTILITY VEHICLES EQUIPPED WITH RECLINING SEATS AND THE EASY-ENTRY FEATURE. THESE VEHICLES EXHIBIT A CONDITION IN WHICH A PINCH POINT EXISTS IN THE RECLINER MECHANISM THAT CAN TRAP AND PINCH A PERSON'S HAND OR FINGER(S) WHEN THE EASY-ENTRY FEATURE IS ACTIVATED.

Consequence: THIS PINCHING CAN CUT THE HAND OR POSSIBLY SEVER THE FINGER(S) WITHOUT PRIOR WARNING.

Remedy: DEALERS WILL INSTALL A PROTECTOR COVER OVER THE RECLINER MECHANISM.