1980 Buick REGAL: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
5 distinct recall campaigns
Not available median reported failure mileage
Scope: 1980 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
5 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
79V205000 · Suspension:Rear
Reported: 1979-09-12 (September 12, 1979)
THE BOLTS THAT ATTACHED THE REAR SUSPENSION CONTROL ARMS TO THE FRAME AND AXLE MAY BE DEFECTIVE AND THE BOLT HEAD MAY SEPARATE FROM THE BOLT SHANK. THIS COULD ALLOW THE CONTROL ARM TO COME LOOSE.
Remedy: THE DEALER WILL REPLACE ALL SUSPECT REAR SUSPENSION CONTROL ARM BOLTS PRIOR TO DELIVERY. THIS WILL BE DONE FREE OF CHARGE.
NHTSA campaign record ↗79V235000 · Exterior Lighting:Turn Signal
Reported: 1979-10-23 (October 23, 1979)
THE INVOLVED VEHICLES MAY HAVE BEEN ASSEMBLED WITH CLEAR LAMP BULBS INSTEAD OF THE CORRECT AMBER BULBS IN FRONT PARK AND TURN SIGNAL LOCATIONS. AS A RESULT, THESE VEHICLES DO NOT CONFORM TO FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 108, "LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT".
Remedy: DEALER WILL INSPECT AND, IF NECESSARY, REPLACE CLEAR PARK AND TURN SIGNAL LAMP BULBS WITH AMBER BULBS AT NO COST TO OWNER.
NHTSA campaign record ↗81V025000 · Suspension:Rear
Reported: 1981-02-25 (February 25, 1981)
THE BOLTS THAT ATTACH THE LOWER REAR CONTROL ARM TO THE FRAME MAY FRACTURE. THE REAR CONTROL ARM SUPPORTS AND POSITIONS THE REAR AXLE. FRACTURE OF THE BOLTS WOULD ALLOW THE CONTROL ARM TO DROP FREE.
Remedy: BOTH REAR CONTROL ARM ATTACHMENT BOLTS WILL BE REPLACED WITHOUT CHARGE.
NHTSA campaign record ↗84V149000 · Power Train:Axle Assembly:Axle Shaft
Reported: 1984-11-24 (November 24, 1984)
REAR AXLE ASSEMBLY MAY HAVE AXLES THAT WERE IMPROPERLY MANUFACTURED. THIS CONDITION MAY RESULT IN SEPARATION OF THE AXLE SHAFT AND WHEEL ASSEMBLY FROM THE VEHICLE.
Remedy: THE DEALER WILL INSPECT THE REAR AXLE TO DETERMINE WHETHER IT WAS MANUFACTURED AT THE BUFFALO PLANT. IF SO, THEY WILL MAKE AXLE MEASUREMENTS AND IF NECESSARY REPLACE OR MODIFY AFFECTED AXLE COMPONENTS WITHOUT CHARGE.
NHTSA campaign record ↗85V048000 · Service Brakes, Hydraulic:Foundation Components:Drum:Wheel Cylinders
Reported: 1985-04-29 (April 29, 1985)
EXCESSIVE ENLARGEMENT OF THE WHEEL CYLINDER PILOT HOLE IN THE REAR BRAKE BACKING PLATE COULD ALLOW THE WHEEL CYLINDER TO ROTATE AND CAUSE LOSS OF BRAKE FLUID. CONSEQUENCE OF DEFECT: A LOSS OF BRAKE FLUID LEADS TO LOSS OF REAR BRAKE ACTION, CREATING THE POTENTIAL FOR AN ACCIDENT. FRONT BRAKES WOULD REMAIN OPERATIONAL.
Remedy: ADD A PART TO PREVENT WHEEL CYLINDER FROM ROTATING.
NHTSA campaign record ↗