1994 Am General HUMMER: complaints, problems and recalls
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
3 distinct recall campaigns
Not available median reported failure mileage
Scope: 1994 model year. Data snapshot: . 0 complaints include usable failure mileage.
Most common problems
No owner complaints are recorded for this selection. A complaint can name multiple components.
Component breakdown
Number of unique complaints naming each component. Top eight shown.
No usable records for this chart.
| Category | Count |
|---|
No records.
Reported problems by failure mileage
Complaint counts in mileage bands. These are not failure rates per vehicle or mile.
| Category | Count |
|---|---|
| Under 25,000 | 0 |
| 25,000 to 49,999 | 0 |
| 50,000 to 74,999 | 0 |
| 75,000 to 99,999 | 0 |
| 100,000 to 149,999 | 0 |
| 150,000 and above | 0 |
Under 25,000: 0; 25,000 to 49,999: 0; 50,000 to 74,999: 0; 75,000 to 99,999: 0; 100,000 to 149,999: 0; 150,000 and above: 0
No usable failure mileage is recorded. 0 complaints have missing, zero or invalid mileage.
Complaints over time
Year the complaint was filed, not the vehicle model year or incident year. The snapshot year is partial.
No usable records for this chart.
| Category | Count |
|---|
No records.
Pattern summary
There is not enough complaint evidence to summarize patterns.
Calculated from recorded counts. An AI narrative has not been published for this selection.
Examples from the source records
Examples provide context, not a representative sample or a verified diagnosis.
Recall history
3 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
94V164000 · Fuel System, Gasoline:Delivery:Hoses, Lines/Piping, And Fittings
Reported: 1994-09-01 (September 1, 1994)
THE OIL PRESSURE SWITCH WHICH CONTROLS THE POWER TO THE ELECTRIC FUEL PUMP CAN FAIL. FAILURE IS DUE TO A MISSING RUBBER SEAL BETWEEN THE SWITCH AND THE WIRING HARNESS. THE MISSING SEAL ALLOWS CONTAMINANTS TO ENTER THE SWITCH CAUSING IT TO FAIL IN THE OPEN OR CLOSED POSITION.
Consequence: IF THE SWITCH FAILS IN THE CLOSED POSITION, THE PUMP WILL CONTINUE TO RUN WHEN THE ENGINE IS OFF, DRAINING THE BATTERY. IF THE SWITCH FAILS IN THE OPEN POSITION IT WILL CAUSE POOR PERFORMANCE AND POSSIBLY STALLING.
Remedy: DEALERS WILL INSPECT THE VEHICLES FOR THE PRESENCE OF THE SEAL. IF THE SEAL IS MISSING, THE SWITCH WILL BE REPLACED AND A NEW SEAL WILL BE INSTALLED.
NHTSA campaign record ↗95V023000 · Vehicle Speed Control
Reported: 1995-02-13 (February 13, 1995)
WATER CAN ACCUMULATE IN THE CRUISE CONTROL CABLE AND IF THE OUTSIDE TEMPERATURE IS BELOW FREEZING AND THE CRUISE CONTROL IS ENGAGED, THE WATER CAN FREEZE CAUSING THE CABLE TO BIND AND NOT RELEASE AS INTENDED WHEN THE BRAKE PEDAL IS APPLIED OR THE SYSTEM IS TURNED OFF AT THE MASTER CRUISE CONTROL SWITCH.
Consequence: THE ENGINE THROTTLE CAN STICK OPEN RESULTING IN LOSS OF THROTTLE CONTROL WITH THE INCREASED POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy: DEALERS WILL REMOVE THE CURRENT CRUISE CONTROL ACTUATOR AND CABLE ASSEMBLY AND INSTALL A NEW ASSEMBLY. ADDITIONALLY, DEALERS WILL CHANGE THE ROUTING OF THE CABLE.
NHTSA campaign record ↗96V049000 · Vehicle Speed Control:Accelerator Pedal
Reported: 1996-03-12 (March 12, 1996)
THE COATING USED TO PROTECT THE ACCELERATOR PEDAL SHAFT IS INCOMPATIBLE WITH THE BRONZE BUSHING THROUGH WHICH THE SHAFT PASSES. OVER TIME, AND IN THE PRESENCE OF A CORROSIVE ENVIRONMENT (WATER, ROAD SALT), THE SHAFT CAN CORRODE INSIDE THE BUSHING INCREASING THE AMOUNT OF FRICTION BETWEEN THE ROTATING SHAFT AND THE STATIONARY BUSHING.
Consequence: A CORRODED ACCELERATOR PEDAL SHAFT CAN CAUSE THE ENGINE THROTTLE TO BIND AND NOT FULLY RETURN TO IDLE WHEN THE OPERATOR'S FOOT IS REMOVED FROM THE ACCELERATOR PEDAL INCREASING THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy: DEALERS WILL INSTALL A REVISED ACCELERATOR PEDAL AND SHAFT ASSEMBLY.
NHTSA campaign record ↗