Terex TL recalls by model year
Explore the records behind recurring owner reports.
Key facts
0 owner complaints analyzed
4 distinct recall campaigns
Not available median reported failure mileage
Scope: 2016 to 2022 model years. Data snapshot: . 0 complaints include usable failure mileage.
Recalls by model year
All campaigns in the snapshot affecting each model year, including recalls announced years later.
Recall campaigns
Shared campaigns appear once in each affected model year.
| Category | Count |
|---|---|
| 2016 | 1 |
| 2019 | 1 |
| 2020 | 1 |
| 2021 | 2 |
| 2022 | 2 |
2016: 1; 2019: 1; 2020: 1; 2021: 2; 2022: 2
Year-by-year records
Recall history
4 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.
16V435000 · Equipment:Mechanical:Winch | Equipment
Reported: 2016-06-14 (June 14, 2016) · Model years: 2016
Terex South Dakota, Inc. (TSD) is recalling certain model year 2016 HR, HRX, LT, LTM, TL, TC, and TCX aerial devices manufactured January 1, 2016, to May 12, 2016. These aerial devices have a hydraulic motor whose shaft may fail resulting in unexpected boom rotation or winch movement.
Consequence: Unexpected boom rotation or winch movement may increase the risk of injury.
Remedy: TSD will notify owners, and instruct owners to inspect the hydraulic motor. Motors within a certain serial number range will be replaced, free of charge. The recall began on August 3, 2016. Owners may contact TSD customer service at 1-800-982-8975. TSD's number for this recall is SN641.
NHTSA campaign record ↗22V674000 · Equipment:Mechanical:Boom/Crane/Ladder
Reported: 2022-09-08 (September 8, 2022) · Model years: 2019, 2020, 2021, 2022
Terex South Dakota, Inc. (Terex) is recalling certain 2019-2022 TL80, TL80/112, and TL100 aerial devices. The welds for the platform leveling cylinder support bosses may crack, which can cause the cylinder support pin to fail and allow the platform to tip.
Consequence: A platform that tips during use increases the risk of an injury.
Remedy: Dealers will install reinforcement plates to the boom tip platform leveling cylinder bosses, and, all TL80/112 aerial devices will have the hydraulic storage latch for the elevator replaced, free of charge. Owner notification letters were mailed on October 13, 2022. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN712.
NHTSA campaign record ↗23V396000 · Equipment:Mechanical:Boom/Crane/Ladder
Reported: 2023-06-02 (June 2, 2023) · Model years: 2021
Terex South Dakota, Inc. (Terex) is recalling certain 2021 TL48 trucks. The subframe which the aerial device bolts to may not be welded properly, which could result in weld failure, allowing the aerial device to fall.
Consequence: An aerial device that falls increases the risk of injury.
Remedy: Dealers will inspect the subframe for cracks and remove and reweld the joint, as necessary, free of charge. Owner notification letters were mailed June 29, 2023. Owners may contact Terex customer service at 1-605-882-4000. Terex's number for this recall is SN719.
NHTSA campaign record ↗22V893000 · Equipment:Mechanical:Boom/Crane/Ladder
Reported: 2022-12-02 (December 2, 2022) · Model years: 2022
Terex South Dakota, Inc. (Terex) is recalling certain 2022 C4000, C5000, C6000, C7000, General, and Trans TL vehicles. A seam in the boom structure may have been improperly welded, causing the weld to crack.
Consequence: A cracked weld may lead to the boom failing, increasing the risk of an injury.
Remedy: Dealers will replace or repair the boom, free of charge. Owner notification letters were mailed on February 8, 2023. Owners may contact Terex's customer service at 1-605-882-4000. Terex's number for this recall is SN715.
NHTSA campaign record ↗