Mercury TRACER recalls by model year

Reported: 1995-06-27 (June 27, 1995) · Model years: 1987, 1988, 1989

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THAT LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

Reported: 1987-06-15 (June 15, 1987) · Model years: 1988

INCORRECT FUEL FILLER NECK ATTACHMENT SCREWS WERE USED TO ATTACH THE NECK TO THE REAR QUARTER PANELS.

Consequence: THIS CONDITION COULD CAUSE A RATTLE BETWEEN THE FUELFILLER PIPE AND THE SURROUNDING BODY STRUCTURE.

Remedy: REPLACE INCORRECT SCREWS WITH NEW BOLT/WASHER ASSEMBLIES.

Reported: 1989-05-22 (May 22, 1989) · Model years: 1988

SOME LAP SHOULDER BELT RETRACTORS WERE BUILT WITH CERTAIN OUT OF TOLERANCE COMPONENTS.

Consequence: RETRACTORS MAY LOCK AT LOW BELT PULL OUT RATES, THISCOULD DISCOURAGE SEAT BELT USAGE.

Remedy: REPLACE FRONT LAP SHOULDER BELT ASSEMBLIES, AS NECESSARY.

Reported: 1992-08-19 (August 19, 1992) · Model years: 1991

FATIGUE CRACKS CAN DEVELOP IN THE SOLDER JOINT BETWEEN THE FUEL RETURN TUBE AND THE FUEL PUMP SENDING UNIT LOCATED AT THE TOP OF THE FUEL TANK.

Consequence: SHOULD A CRACK DEVELOP, FUEL VAPOR CAN ESCAPE FROM THETANK WHEN THE TANK IS FULL, AND A SMALL AMOUNT OF FUEL CAN LEAK FROM THE CRACK.FUEL LEAKS CAN RESULT IN FIRE WHEN EXPOSED TO A SOURCE OF IGNITION.

Remedy: INSTALL A NEW FUEL PUMP SENDING ASSEMBLY.

Reported: 1993-04-15 (April 15, 1993) · Model years: 1991

THE ROLL PINS SECURING THE IGNITION LOCK IN THE STEERING COLUMN HOUSING CAN SEPARATE OR MOVE OUT OF POSITION.

Consequence: THE IGNITION LOCK CYLINDER MAY DISENGAGE FROM THESTEERING COLUMN HOUSING WHICH COULD CAUSE THE STEERING COLUMN TO LOCK UP,RESULTING IN LOSS OF VEHICLE CONTROL AND A POSSIBLE ACCIDENT.

Remedy: IF ONE OR BOTH OF THE ROLL PINS ARE MISSING OR NOT FULLY INSERTED, THE IGNITION LOCK HOUSING WILL BE REPLACED, ALONG WITH THE DOOR-LOCKS AND THE LIFTGATE OR DECK-LID LOCKS SO THAT KEY COMPATIBILITY IS MAINTAINED. IF BOTH PINS ARE PRESENT AND FULLY INSERTED, A PLASTIC SNAP-ON SLEEVE WILL BE INSTALLED AS A PRECAUTION TO PREVENT THE ROLL PINS FROM COMING OUT.

Reported: 1992-07-13 (July 13, 1992) · Model years: 1992

THE STOP LAMP SWITCHES COULD INTERMITTENTLY MALFUNCTION RESULTING IN THE STOP LAMPS NOT ILLUMINATING WHEN THE BRAKES ARE APPLIED.

Consequence: THIS COULD RESULT IN FOLLOWING MOTORISTS NOT BEINGSIGNALED THAT THE VEHICLE IS BRAKING, AND COULD RESULT IN A COLLISION.

Remedy: REPLACE THE FAULTY STOP LAMP SWITCHES.

Reported: 1994-11-10 (November 10, 1994) · Model years: 1994, 1995

THE DRIVER SIDE AIR BAG MODULE CAN HAVE AN INADEQUATELY WELDED INFLATOR CANISTER.

Consequence: IN THE EVENT OF A COLLISION, THE WELD SEAM CAN SEPARATE, CAUSING THE AIR BAG TO FAIL TO DEPLOY PROPERLY AND HOT GASES TO BE EXPELLED FROM THE BACK OF THE STEERING WHEEL. THIS CAN RESULT IN AN INCREASED RISK OF PERSONAL INJURY FROM THE HOT GASES AND THE AIR BAG FAILURE.

Remedy: DEALERS WILL INSTALL A NEW AIR BAG MODULE.

Reported: 1997-09-03 (September 3, 1997) · Model years: 1995

VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH 1.9L ENGINES, BUILT AT THE HERMOSILLO OR WAYNE ASSEMBLY PLANTS AND ORIGINALLY SOLD OR CURRENTLY REGISTERED IN NEVADA, FLORIDA, HAWAII, TEXAS, CALIFORNIA, LOUISIANA, GEORGIA, SOUTH CAROLINA, MISSISSIPPI, OKLAHOMA, ALABAMA AND ARKANSAS. CRACKS CAN DEVELOP IN THE FUEL TANK NEAR THE HEAT SHIELD ATTACHMENT RESULTING IN FUEL LEAKAGE IF THE CRACKS GO THROUGH THE FUEL TANK WALL.

Consequence: FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A VEHICLE FIRE.

Remedy: DEALERS WILL REMOVE THE HEAT SHIELD ATTACHMENTS. THIS WILL NOT AFFECT HEAT SHIELD LOCATION OR FUNCTION, AS THE ATTACHMENTS ARE INTENDED TO KEEP THE SHIELD IN PLACE UNTIL THE FUEL TANK IS INSTALLED IN THE VEHICLE. AFTER INSTALLATION, THE FUEL TANK STRAPS RETAIN THE HEAT SHIELD.

Reported: 1997-09-03 (September 3, 1997) · Model years: 1995

VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH 1.9L ENGINES, BUILT AT THE HERMOSILLO ASSEMBLY PLANT AND ORIGINALLY SOLD OR CURRENTLY REGISTERED IN ARIZONA. CRACKS CAN DEVELOP IN THE FUEL TANK NEAR THE HEAT SHIELD ATTACHMENT RESULTING IN FUEL LEAKAGE IF THE CRACKS GO THROUGH THE FUEL TANK WALL.

Consequence: FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE CAN RESULT IN A VEHICLE FIRE.

Remedy: DEALERS WILL REMOVE THE HEAT SHIELD ATTACHMENTS. THIS WILL NOT AFFECT HEAT SHIELD LOCATION OR FUNCTION, AS THE ATTACHMENTS ARE INTENDED TO KEEP THE SHIELD IN PLACE UNTIL THE FUEL TANK IS INSTALLED IN THE VEHICLE. AFTER INSTALLATION, THE FUEL TANK STRAPS RETAIN THE HEAT SHIELD.

Reported: 2002-12-09 (December 9, 2002) · Model years: 1997

ON CERTAIN PASSENGER VEHICLES, THE INTEGRATED AIR BAG MONITOR (IABM) CAN BE CONTAMINATED WITH WATER OR OTHER LIQUIDS AND COULD EXPERIENCE INTERNAL ELECTRICAL SHORTING.

Consequence: THIS MAY, IN TURN, CAUSE THE AIR BAG READINESS LIGHT TO ILLUMINATE AND IN VERY RARE OCCURRENCES, AIR BAG DEPLOYMENT, MELTED WIRING, OR FIRE MAY OCCUR.

Remedy: DEALERS WILL INSTALL THE SHIELD OVER THE IABM AND APPLY NYOGEL GREASE TO THE CONNECTOR. OWNER NOTIFICATION BEGAN FEBRUARY 11, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT FORD AT 1-866-436-7332.