Holiday Rambler ADMIRAL SE recalls by model year

Reported: 2002-09-09 (September 9, 2002) · Model years: 2002, 2003

ON CERTAIN CLASS A MOTOR HOMES, THE FLOOR TRUSS NETWORK SUPPORT SYSTEM HAS A POTENTIAL TO WEAKEN CAUSING INTERNAL AND EXTERNAL FEATURES TO BECOME MISALIGNED. THE AFFECTED VEHICLES ARE 1999 - 2003 CLASS A MOTOR HOMES MANUFACTURED ON F53 20,500 POUND GROSS VEHICLE WEIGHT RATING (GVWR), FORD CHASSIS, AND 2000-2003 CLASS A MOTOR HOMES MANUFACTURED ON W-22 22,000 POUND GVWR, WORKHORSE CHASSIS.

Consequence: CONDITIONS CAN RESULT IN THE BOTTOMING OUT THE SUSPENSION AND AMPLIFICATION OF THE STRESS PLACED ON THE FLOOR TRUSS NETWORK. THE ADDITIONAL STRESS CAN RESULT IN THE FRACTURE OF WELDS SECURING THE FLOOR TRUSS NETWORK SYSTEM TO THE CHASSIS FRAME RAIL AND/OR FRACTURE OF THE FLOOR TRUSS NETWORK SUPPORT SYSTEM. THE POSSIBILITY EXISTS THAT THERE COULD BE DAMAGE TO ELECTRICAL WIRING AND/OR FUEL LINES WHICH COULD POTENTIALLY LEAD TO A FIRE.

Remedy: DEALERS WILL INSPECT THE FLOOR TRUSS NETWORK SUPPORT SYSTEM, REINFORCE THE EXISTING STRUCTURE, AND REPAIR, AS NEEDED, THE FLOOR TRUSS NETWORK SUPPORT. OWNER NOTIFICATION BEGAN NOVEMBER 5, 2002. OWNERS SHOULD CONTACT MONACO AT 1-800-685-6545.

Reported: 2002-10-22 (October 22, 2002) · Model years: 2002, 2003

ON CERTAIN MOTOR HOMES, THE BRAKE ASSEMBLIES EXHIBIT ELEVATED TEMPERATURES THAT CAN LEAD TO CATASTROPHIC DETERIORATION OF THE WHEEL END COMPONENTS SUCH AS BEARINGS, RACES, SPINDLES, KNUCKLES, SEALS, HUBS, ROTORS, PATCH BOLTS, CALIPERS, BRAKE PADS, AND ABS SENSORS.

Consequence: THIS COULD RESULT IN LOSS OF CONTROL, AND/OR THE POTENTIAL FOR A FIRE.

Remedy: DEALERS WILL INSPECT THE FRONT AND REAR BRAKE CALIPERS FOR CORROSION AND REPLACE OR REBUILD THE CALIPERS AS NECESSARY. THE RECALL BEGAN ON AUGUST 18, 2004. OWNERS SHOULD CONTACT MONACO AT 1-800-685-6545.

Reported: 2003-03-05 (March 5, 2003) · Model years: 2002, 2003

CERTAIN MOTOR HOME CHASSIS FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 105, "HYDRAULIC AND ELECTRIC BRAKE SYSTEMS." THE BRAKE SYSTEM WARNING INDICATOR MAY NOT FUNCTION AS REQUIRED BY STANDARD.

Consequence: IN SOME OF THE AFFECTED VEHICLES, THE BRAKE SYSTEM WARNING INDICATOR WILL NOT ILLUMINATE WHEN THE IGNITION IS IN THE START POSITION OR FOR A LOW BRAKE FLUID CONDITION, IF THE BODY BUILDER RELIED SOLELY UPON FORD'S IVM COMPLIANCE STATEMENT FOR THE BRAKE SYSTEM WARNING INDICATOR.

Remedy: DEALERS WILL REPAIR THE BRAKE WARNING LAMP CIRCUIT. OWNER NOTIFICATION BEGAN MAY 7, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT MONACO COACH AT 1-877-477-6226.

Reported: 2007-01-16 (January 16, 2007) · Model years: 2002, 2003

ON CERTAIN CLASS A MOTOR H0MES BUILT WITH GASOLINE ENGINES, THE FRAME EXTENSION LOWER FLANGE MAY CRACK ALLOWING THE HITCH TO BEND AND POSSIBLY SEPARATE FROM THE MOTOR HOME.

Consequence: THIS COULD RESULT IN SEPARATION OF THE TOWED VEHICLE.

Remedy: DEALERS WILL ADD AN ADDITION OF TWO PIECES OF ANGLE STEEL TO THE FRAME EXTENSION AND HITCH MOUNTING POINT IN ORDER TO REINFORCE THE FRAME EXTENSION FLANGE FREE OF CHARGE. THE RECALL BEGAN ON FEBRUARY 15, 2007. OWNERS MAY CONTACT MONACO AT 877-466-6226. NOTE: THE ENDING MANUFACTURING DATE FOR INDIANA BUILT MOTOR HOMES IS MARCH 8, 2002 WHILE THE OREGON BUILT MOTOR HOMES WERE BUILT THROUGH NOVEMBER 2002. THE FEDERAL ID LABEL LOCATED ON THE WALL NEXT TO THE DRIVER'S SEAT SPECIFIES IN WHICH STATE THE MOTOR HOME WAS BUILT.

Reported: 2006-06-23 (June 23, 2006) · Model years: 2003, 2004, 2005

CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH ACTIA CORPORATE INSTRUMENT CLUSTER FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 101, 'CONTROLS AND DISPLAYS,' AND NO. 105, 'HYDRAULIC AND ELECTRIC BRAKE SYSTEMS.' IF THE BRAKE FAIL INPUT FALLS BELOW A VOLTAGE OF 1.5V, THE BRAKE FAILURE LAMP AND ALARM WILL BE ACTIVATED. ALSO ACTIVATION OF THE ABS TELLTALE WHEN THE ABS IS NOT PROPERLY FUNCTIONING DOES NOT ALWAYS OCCUR.

Consequence: AT NIGHT THE INSTRUMENT CLUSTER LIGHTS MAY FAIL AND THE DRIVER MAY NOT BE ABLE TO SEE THE INSTRUMENT PANEL GAUGES AND THE BRAKE WARNING LIGHT INDICATOR WHICH COULD INCREASING THE RISK OF A CRASH.

Remedy: WORKHORSE IS CONDUCTING THIS RECALL (PLEASE SEE 04V195000) AND WILL REPROGRAM THE INSTRUMENT PANEL CLUSTER FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 1-877-246-7731 OR MONACO AT 1-800-685-6545.

Reported: 2005-03-01 (March 1, 2005) · Model years: 2004, 2005

ON CERTAIN CLASS A MOTOR HOMES BUILT ON WORKHORSE CHASSIS,THE BATTERY CABLES MAY NOT BE SECURED PROPERLY INSIDE OF THE CHASSIS' FRAME RAIL. THE BATTERY CABLES MAY BE LOCATED TOO NEAR THE ENGINE EXHAUST.

Consequence: THIS COULD POTENTIALLY MELT THE BATTERY CABLE AND CAUSE A BACK FEED THROUGH THE CHASSIS 12V SYSTEM WHICH COULD RESULT IN INJURY OR LOSS.

Remedy: DEALERS WILL INSPECT THE BATTERY CABLE TO SEE IF THE CABLE IS PROPERLY MOUNTED INSIDE OF THE CHASSIS FRAME RAIL. IF NECESSARY, THE BATTERY CABLE WILL BE MOUNTED SECURELY IN EXISTING HOLES IN FRAME RAIL FREE OF CHARGE. THE RECALL BEGAN ON MARCH 18, 2005. OWNERS MAY CONTACT MONACO AT 1-800-685-6545.

Reported: 2006-09-19 (September 19, 2006) · Model years: 2004, 2005, 2006

ON CERTAIN MOTOR HOMES BUILT ON WORKHORSE CHASSIS AND EQUIPPED WITH GM 8.1L V8 ENGINES, IMPROPER HARDENING DURING THE HEAT TREATMENT PROCESS CAN CAUSE THE FUEL RAIL PULSE DAMPER RETAINER CLIP TO FRACTURE, RESULTING IN INADEQUATE RETENTION OF THE DAMPER. IF THE DAMPER BECOMES LOOSE, FUEL COULD BE PUMPED BY THE FUEL PUMP INTO THE UNDER HOOD AREA.

Consequence: IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE COULD RESULT.

Remedy: WORKHORSE IS HANDLING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN (PLEASE SEE 06V225). DEALERS WILL REPLACE THE FUEL RAIL PULSE DAMPER RETAINER CLIPS ON THESE ENGINES FREE OF CHARGE. OWNERS MAY CONTACT WORKHORSE AT 877-294-6773 OR MONACO AT 1-800-685-6545.

Reported: 2006-06-22 (June 22, 2006) · Model years: 2006

CERTAIN MOTOR HOME CHASSIS BUILT ON WORKHORSE CHASSIS MAY HAVE BEEN EQUIPPED WITH INCORRECT STEERING INTERMEDIATE SHAFTS. THE SPLINE CAN STRIP WHILE THE STEERING WHEEL IS BEING TURNED.

Consequence: THIS STEERING CONDITION COULD RESULT IN A LOSS OF STEERING CONTROL, INCREASING THE RISK OF A CRASH.

Remedy: WORKHORSE IS CONDUCTING THIS RECALL (PLEASE SEE 06V148000) AND WILL INSPECT AND, IF NECESSARY, REPLACE THE STEERING INTERMEDIATE SHAFT. OWNERS MAY CONTACT WORKHORSE AT 1-877-294-6773 OR MONACO AT 1-800-685-6545.

Reported: 2008-11-03 (November 3, 2008) · Model years: 2006

MONACO IS RECALLING 202 MY 2006 MONARCH SE, MY 2009 RIPTIDE, MY 2006 HOLIDAY RAMBLER ADMIRAL SE, MY 2007-2009 ARISTA, MY 2007-2009 SAFARI PASSAGE, MY 2006 SIMBA AND TREK GAS, AND MY 2006-2007 R-VISION TRAIL-LITE AND TRAIL-AIRE MOTOR HOMES BUILT ON WORKHORSE CHASSIS. THE CASTLE NUT THAT RETAINS THE STEERING DRAG LINK TO THE PITMAN ARM MAY HAVE BEEN IMPROPERLY TORQUED DURING ASSEMBLY. THE IMPROPER TORQUE MAY HAVE DAMAGED THE CASTLE NUT AND COMPROMISED THE INTEGRITY OF THE CONNECTION.

Consequence: IF THE DRAG LINK WERE TO SEPARATE FROM THE PITMAN ARM, THE DRIVER WOULD NOT HAVE DIRECTIONAL CONTROL OF THE VEHICLE POSSIBLY CAUSING A CRASH.

Remedy: MONACO IS WORKING WITH WORKHORSE TO REPLACE AND PROPERLY TIGHTEN THE CASTLE NUT THAT RETAINS THE STEERING DRAG LINK TO THE PITMAN ARM (PLEASE SEE 08V442). OWNERS MAY CONTACT WORKHORSE AT 1-877-946-7731 OR MONACO AT 1-800-685-6545.