Eagle TALON recalls by model year

Reported: 1990-03-21 (March 21, 1990) · Model years: 1990

OPERATION OF SUNROOF IN "NON-STANDARD" MANNER MAY CAUSE MALE HINGE DISENGAGEMENT FROM THE ROOF HINGE RECEIVER.

Consequence: THE SUNROOF GLASS COULD DETACH FROM THE ROOF AND RESULTIN INJURY TO OCCUPANTS OR PERSONS IN THE VICINITY, ESPECIALLY IF THIS OCCURS WHILE THE VEHICLE IS IN MOTION.

Remedy: REPLACE MALE HINGE WITH A MODIFIED VERSION TO INCREASE ROOF HINGE RECEIVER RETENTION ABILITY.

Reported: 1990-06-01 (June 1, 1990) · Model years: 1990

DILUTED PRIMER MAY HAVE BEEN USED ON THE WINDSHIELD OPENING FLANGES PRIOR TO WINDSHIELD GLASS INSTALLATION WHICH WOULD NOT PROVIDE THE RETENTION REQUIRED BY FMVSS 212.

Consequence: WINDSHIELDS WOULD NOT PREVENT EJECTION OF VEHICLEOCCUPANTS DURING A VEHICLE CRASH, WHICH CAUSES SERIOUS INJURIES AND FATALITIES.

Remedy: REPLACE WINDSHIELDS, ASSOCIATED PARTS, AND PRIMER.

Reported: 1995-05-24 (May 24, 1995) · Model years: 1990, 1991

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

Reported: 1998-04-07 (April 7, 1998) · Model years: 1990, 1991, 1992, 1993, 1994, 1995, 1996, 1997, 1998

VEHICLE DESCRIPTION: PASSENGER VEHICLES. LOCKUP OF THE TRANSFER CASE CAN OCCUR DUE TO INSUFFICIENT LUBRICATION.

Consequence: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE VEHICLES FOR ADEQUACY OF THE TRANSFER CASE OIL VOLUME, TRANSFER CASE OIL LEAKAGE, AND OPERATIONAL DEGRADATION OF THE TRANSFER CASE MECHANISM. IF OIL VOLUME IS INSUFFICIENT, THE APPROPRIATE AMOUNT OF OIL WILL BE ADDED. IF THERE IS TRANSFER CASE OIL LEAKAGE, AFFECTED COMPONENTS WILL BE REPLACED. IF THE TRANSFER CASE SHOWS OPERATIONAL DEGRADATION, THE TRANSFER CASE WILL BE REPLACED.

Reported: 2000-12-18 (December 18, 2000) · Model years: 1995, 1996, 1997, 1998

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE. ALSO, MMC HAS ADDED THE POTENTIAL OF LEAKING MOISTURE, WHICH CAN CAUSE THE BALL STUD TO CORRODE.

Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH. THIS CAMPAIGN SUPERCEDES MMC'S PREVIOUS SAFETY RECALL CAMPAIGN, SEE 99V-066.

Remedy: DEALERS WILL INSPECT THE LOWER LATERAL ARM BALL JOINT FOR WEAR. BALL JOINTS THAT EXHIBIT WEAR BEYOND THE ESTABLISHED TOLERANCE WILL BE REPLACED WITH NEWLY DESIGNED LATERAL ARM BALL JOINTS. BALL JOINTS THAT ARE WITHIN THE ESTABLISHED TOLERANCE WILL BE CLEANED AND A SPECIAL SEALANT WILL BE APPLIED TO PREVENT INTRUSION OF MOISTURE.

Reported: 1994-08-08 (August 8, 1994) · Model years: 1995

THE HEADLAMP SUPPORT PANEL CAN DEVELOP A FATIGUE CRACK WHERE THE ANTI-LOCK BRAKE SYSTEM (ABS) HYDRAULIC UNIT IS ATTACHED, ALLOWING THE HYDRAULIC UNIT TO FALL DOWN.

Consequence: LOSS OF BRAKING CAN RESULT IF THE ABS HYDRAULIC UNIT FALLS. THIS CAN RESULT IN A VEHICLE ACCIDENT.

Remedy: DEALERS WILL CONNECT THE ABS HYDRAULIC UNIT ATTACHMENT POINT AT A RIGID PORTION OF THE HEADLAMP SUPPORT PANEL WITH A BRACKET AND REINFORCE THE HEADLAMP SUPPORT PANEL BY ADDING A BACK PLATE.

Reported: 1996-08-27 (August 27, 1996) · Model years: 1995, 1996

THE FUEL TANK GASKETS FOR THE FUEL PUMP AND/OR GAUGE UNIT GASKET COULD HAVE BEEN INCORRECTLY INSTALLED ALLOWING FUEL OR FUMES TO ESCAPE.

Consequence: IF AN IGNITION SOURCE WERE PRESENT, THE FUEL LEAKAGE COULD RESULT IN A FIRE.

Remedy: DEALERS WILL INSPECT THE FUEL TANK AND IF THE GASKETS ARE FOUND TO BE LEAKING, REPLACE THE FUEL TANK, CAPS AND GASKETS.

Reported: 1999-04-05 (April 5, 1999) · Model years: 1995, 1996

VEHICLE DESCRIPTION: PASSENGER VEHICLES. IF THE RUBBER BOOTS ON THE LOWER LATERAL ARM BALL JOINTS OF THE FRONT SUSPENSION WERE DAMAGED DURING ASSEMBLY, DIRT AND WATER CAN INTRUDE.

Consequence: THIS CONDITION COULD CAUSE THE LOWER LATERAL ARM BALL JOINT TO SEPARATE, INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL INSPECT THE RUBBER BOOTS, AND IF THE BOOT IS DAMAGED, THEY WILL REPLACE THE LOWER LATERAL ARM AND BALL JOINT ON THE AFFECTED VEHICLES.

Reported: 1997-08-08 (August 8, 1997) · Model years: 1997

THE HEADREST GUIDE BRACKET WAS IMPROPERLY WELDED TO THE SEAT BACK FRAME ON THE PASSENGER SIDE SEAT BACK ASSEMBLIES ONLY.

Consequence: THE HEADREST SUPPORT BRACKET CAN BREAK, INCREASING THE RISK OF PERSONAL INJURY.

Remedy: DEALERS WILL REPLACE THE PASSENGER SEAT BACK ASSEMBLY WITH A NEW ASSEMBLY.

Reported: 1998-03-03 (March 3, 1998) · Model years: 1998

VEHICLE DESCRIPTION: PASSENGER VEHICLES. THE DASH PANEL PAD CAN SHIFT INTERFERRING WITH THE THROTTLE CABLE CONTROL.

Consequence: THE THROTTLE CABLE CONTROL WOULD NOT RETURN TO IDLE INCREASING THE RISK OF A VEHICLE CRASH.

Remedy: DEALERS WILL REMOVE A PORTION OF THE DASH PANEL PAD SO IT CANNOT INTERFERE WITH THE THROTTLE CABLE CONTROL.