Dodge STEALTH recalls by model year

Reported: 2002-05-14 (May 14, 2002) · Model years: 1991, 1992, 1993, 1994, 1995, 1996

ON CERTAIN PASSENGER VEHICLES BUILT BY MITSUBISHI MOTOR CORPORATION FOR DAIMLERCHRYSLER, A CONDITION EXISTS THAT ALLOWS OIL TO LEAK FROM THE ALL-WHEEL DRIVE TRANSFER CASE.

Consequence: LOW OIL LEVELS IN THE TRANSFER CASE COULD CAUSE BEARING DAMAGE AND RESULT IN DRIVE TRAIN LOCKUP, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT THE TRANSFER CASE FOR INDICATIONS OF OIL LEAKAGE. VEHICLES THAT HAVE NO OIL LEAKAGE WILL HAVE THE TRANSFER CASE OIL CHANGED. VEHICLES THAT HAVE OIL LEAKAGE WILL HAVE THE TRANSFER CASE RESEALED OR REPLACED IF NECESSARY. OWNER NOTIFICATION IS EXPECTED TO BEGIN DECEMBER 2, 2002. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT DAIMLERCHRYSLER AT 1-800-853-1403.

Reported: 1993-04-08 (April 8, 1993) · Model years: 1991

A CONDITION EXISTS THAT ALLOWS OIL TO LEAK FROM THE ALL WHEEL DRIVE TRANSFER CASE. LOW OIL LEVELS IN THE TRANSFER CASE CAN CAUSE BEARING DAMAGE AND FAILURE.

Consequence: BEARING FAILURE IN THE TRANSFER CASE RESULTS INPOWER TRAIN LOCKUP WITHOUT PRIOR WARNING, WHILE THE VEHICLE IS AT HIGHWAY SPEED.THIS COULD CAUSE IN A LOSS OF VEHICLE CONTROL AND AN ACCIDENT.

Remedy: INSTALL A C-RING TO TRANSFER CASE TO PREVENT OIL LEAKAGE, OR REPLACE TRANSFER CASE TO MAINTAIN SUFFICIENT OIL LEVELS IN THE TRANSFER CASE.

Reported: 1995-05-24 (May 24, 1995) · Model years: 1991

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

Reported: 1996-10-08 (October 8, 1996) · Model years: 1991, 1992, 1993, 1994

UNDER CONDITIONS OF FULL LOCK STEERING AND FULL SUSPENSION TRAVEL, THE LEFT OR RIGHT FRONT WHEEL-SIDE BRAKE HOSE CAN CRACK, RESULTING IN BRAKE FLUID LEAKAGE.

Consequence: BRAKE FLUID LEAKAGE WILL CAUSE ILLUMINATION OF THE BRAKE WARNING LAMP AND REDUCTION IN BRAKING EFFECTIVENESS INCREASING THE RISK OF A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE THE LEFT AND RIGHT FRONT WHEEL-SIDE BRAKE HOSES WITH REVISED HOSE ASSEMBLIES.