Chevrolet LUMINA APV recalls by model year

Reported: 1989-10-02 (October 2, 1989) · Model years: 1990

THE REAR MODULAR SEAT FRAME HOLD-DOWN HOOKS MAY NOT MEET THE REQUIRED PULL FORCE AT THE REAR SET ANCHORAGE.

Consequence: VEHICLES WOULD NOT CONFORM TO FMVSS 207.

Remedy: REPLACE REAR HOLD DOWN HOOKS AND PIVOT RIVETS WITH HEAT TREATED HARDWARE.

Reported: 1991-03-15 (March 15, 1991) · Model years: 1990

A RIGHT HAND SEAT/SHOULDER BELT RETRACTOR MAY HAVE BEEN INSTALLED IN THE SECOND ROW LEFT HAND SEAT POSITION (DIRECTLY BEHIND DRIVER).

Consequence: THE INCORRECT RETRACTOR MAY CAUSE THE BELTS TO LOCK UPIF THE VAN IS PARKED ON A STEEP GRADE. AS A RESULT OF THIS, THE OCCUPANT COULDNOT EXTEND THE BELT FOR USE.

Remedy: REPLACE SHOULDER BELT ASSEMBLY.

Reported: 1997-04-08 (April 8, 1997) · Model years: 1990, 1991

VEHICLE DESCRIPTION: PASSENGER VEHICLES AND MINI VANS ORIGINALLY SOLD OR CURRENTLY REGISTERED IN THE FOLLOWING STATES: CONNECTICUT, ILLINOIS, INDIANA, MAINE, MASSACHUSETTS, MICHIGAN, NEW HAMPSHIRE, NEW JERSEY, NEW YORK, OHIO, PENNSYLVANIA, RHODE ISLAND, VERMONT AND WISCONSIN. THE REAR CRADLE BOLTS PULL THROUGH THE RETAINERS DUE TO CORROSION OF THE RETAINER. IF BOTH BOLTS PULL THROUGH, THE REAR CRADLE WOULD NOT LONGER BE SUPPORTED AT THESE MOUNTING LOCATIONS AND THE STEERING INTERMEDIATE SHAFT CAN SEPARATE FROM THE STEERING GEAR.

Consequence: IF THIS WERE TO OCCUR WHILE THE VEHICLE WAS IN MOTION, A VEHICLE CRASH COULD RESULT.

Remedy: DEALERS WILL REPLACE THE REAR CRADLE BOLTS AND RETAINERS.

Reported: 1994-01-04 (January 4, 1994) · Model years: 1992, 1993

VEHICLE FAILS TO CONFORM TO FMVSS NO. 209, "SEAT BELT ASSEMBLIES." THE SAFETY BELT OF THE LEFT THIRD ROW SEAT ON THE SIX PASSENGER VAN AND THE CENTER SECOND ROW SEAT OF THE SEVEN PASSENGER VAN MAY LOCK UP AND CANNOT BE WITHDRAWN FROM THE RETRACTOR.

Consequence: CONSEQUENCE OF NON-COMPLIANCE: THE OCCUPANTS OF THESE SEATS WILL NOT BE ABLE TO USE THE AFFECTED BELT. IN THE EVENT OF A VEHICLE CRASH, UNBELTED OCCUPANTS ARE AT INCREASED RISK OF INJURY.

Remedy: OWNERS ARE BEING ASKED TO INSPECT THEIR VEHICLES TO DETERMINE IF THE SUSPECT RETRACTOR EXHIBITS A LOCKUP CONDITION. BASED ON THIS INSPECTION, DEALERS WILL REPLACE THE SAFETY BELTS IF THE BELT LOCKS UP. REPLACEMENT OF THE SUSPECT SAFETY BELT WILL BE AVAILABLE TO CONSUMERS FOR THE LIFE OF THE VEHICLE.

Reported: 1996-01-23 (January 23, 1996) · Model years: 1992, 1993, 1994, 1995

VEHICLE DESCRIPTION: PASSENGER VEHICLES MANUFACTURED FROM AUGUST 1991 THROUGH JULY 1995. THE TRANSMISSION OIL COOLER LINE CAN SEPARATE WHEN THE VEHICLE IS OPERATED IN LOW TEMPERATURES IN COMBINATION WITH HIGH TRANSMISSION LOADS.

Consequence: VEHICLE FIRES CAN OCCUR DUE TO THE SPILLAGE OF TRANSMISSION FLUID.

Remedy: DEALERS WILL REPLACE THE TRANSMISSION OIL COOLER LINES.

Reported: 1994-05-24 (May 24, 1994) · Model years: 1993, 1994

THE SECOND ROW, RIGHT HAND SHOULDER BELT CAN BECOME "PINCHED" BETWEEN THE SEAT AND THE DOOR FRAME PILLAR TRIM. THE SHOULDER BELT MAY NOT RETRACT PROPERLY, WHICH DOES NOT COMPLY WITH THE REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION." THE 1994 VEHICLES HAVE AN OPTIONAL INTEGRAL (BUILT IN) CHILDSEAT INSTALLED NEXT TO THE POWER SLIDING SIDE DOOR. THE 1993 INVOLVED VEHICLES HAVE STANDARD SEATS IN THAT SAME POSITION.

Consequence: IMPROPER SHOULDER BELT RETRACTION DOES NOT PROVIDE ADEQUATE PROTECTION TO THE SEAT OCCUPANT IN THE EVENT OF A SUDDEN STOP OR COLLISION.

Remedy: DEALERS WILL REPLACE THE DOOR FRAME PILLAR TRIM PANEL WITH A REDESIGNED TRIM PANEL. ALSO, A CAUTION LABEL WILL BE APPLIED TO THE CHILD SEAT ADVISING THE OWNER NOT TO INSTALL THE SEAT TO THE PASSENGER SIDE OF A VEHICLE WITH A POWER SLIDING SIDE DOOR.

Reported: 1993-12-13 (December 13, 1993) · Model years: 1994

THE SAFETY BELT RETRACTORS FOR THE REAR CENTER POSITION ARE MISSING A PAWL SPRING AND IN CASE OF AN ACCIDENT, WILL ALLOW THE SAFETY BELT WEBBING TO EXTEND BEYOND THE MINIMUM REQUIREMENTS OF FMVSS NO. 208, "OCCUPANT CRASH PROTECTION."

Consequence: IN THE EVENT OF AN ACCIDENT THE SAFETY BELT WOULD NOTRESTRAIN THE OCCUPANT, SUBJECTING THE OCCUPANT TO INCREASED RISK OF INJURIES.

Remedy: DEALERS WILL INSPECT THE SAFETY BELT RETRACTOR ASSEMBLY AND REPLACE THE RETRACTOR IF THE PAWL SPRING IS MISSING.

Reported: 1994-01-21 (January 21, 1994) · Model years: 1994

THE THIRD ROW SAFETY BELT RETRACTORS MAY BE INSTALLED INCORRECTLY AND MAY LOCK-UP WHEN THE VEHICLE IS ON SLOPES OF LESS THAN 15 DEGREES, WHICH DOES NOT COMPLY WITH FMVSS NO. 209, "SEAT BELT ASSEMBLIES."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: PASSENGERS SEATED IN THESE POSITON MAYBE UNABLE TO EXTRACT AND FASTEN THEIR SEAT BELTS UNTIL THE VEHICLE IS MOVED TO A MORE LEVEL SURFACE. UNBELTED OCCUPANTS ARE MORE AT RISK OF INJURY IN THE EVENT OF A COLLISION THAN THOSE USING SAFETY BELTS.

Remedy: DEALERS WILL REMOVE THIRD ROW SAFETY BELT RETRACTORS AND REINSTALL THEM PROPERLY.

Reported: 1995-03-20 (March 20, 1995) · Model years: 1995

IMPROPERLY MANUFACTURED BRAKE PEDAL ARM CAUSES THE BRAKE PEDAL ARM TO FRACTURE DURING BRAKING.

Consequence: THIS CONDITION CAN RESULT IN A LOSS OF BRAKE OPERATION INCREASING BRAKING DISTANCE AND THE POTENTIAL FOR A VEHICLE ACCIDENT.

Remedy: DEALERS WILL REPLACE ALL SUSPECT BRAKE PEDAL ASSEMBLIES.

Reported: 1995-11-03 (November 3, 1995) · Model years: 1995

THESE VEHICLES WERE ASSEMBLED WITH THROTTLE CABLE SUPPORT BRACKETS THAT COULD CONTACT THE THROTTLE LEVER SYSTEM AND INHIBIT THE THROTTLE RETURN. THIS DOES NOT MEET THE REQUIREMENTS OF FMVSS NO. 124, "ACCELERATOR CONTROL SYSTEMS."

Consequence: CONSEQUENCE OF NON-COMPLIANCE: THE THROTTLE MAY FAITL TO RETURN QUICKLY CAUSING THE ENGINE SPEED TO NOT DECREASE TO A LEVEL ANTICIPATED BY THE DRIVER.

Remedy: DEALERS WILL REPLACE THE THROTTLE CABLE SUPPORT BRACKET.

Reported: 2002-11-04 (November 4, 2002) · Model years: 1996

CERTAIN PASSENGER VEHICLES AND MINI VANS HAVE LOWER PINION BEARINGS IN THE POWER RACK AND PINION ASSEMBLY IN WHICH THE RETAINER TABS WERE NOT CRIMPED PROPERLY. THESE AND SOME OTHER RETAINERS USED IN VEHICLES ASSEMBLED BETWEEN JANUARY 1, 1996 AND OCTOBER 31, 1997, COULD FAIL AND PERMIT THE BALL BEARINGS TO ESCAPE.

Consequence: IF THIS OCCURS, THE PINION SHAFT CAN BE FORCED UPWARD DURING LEFT TURNS AND BACK DOWN AS THE STEERING WHEEL IS MOVED BACK AND TO THE RIGHT. IF THE PINION SHAFT MOVES FURTHER, THE DRIVER WILL NEED TO EXERT MORE EFFORT TO TURN THE STEERING WHEEL, SIMILAR TO A VEHICLE WITHOUT POWER ASSISTED STEERING. IF THE PINION SHAFT MOVES EVEN FURTHER, THE DRIVER WILL REQUIRE MUCH HIGHER EFFORT TO TURN LEFT AND MAY NOT BE ABLE TO TURN THE WHEEL AS MUCH AS INTENDED. WITH THE MAXIMUM PINION SHAFT MOVEMENT, WHICH REQUIRES INTERNAL GEAR COMPONENT DAMAGE, THE DRIVER CAN ENCOUNTER HIGH RESISTANCE TO TURNING LEFT, FOLLOWED BY UNINTENDED POWER ASSIST TO THE RIGHT. IN ANY OF THESE CONDITIONS, A CRASH COULD OCCUR.

Remedy: DEALERS WILL INSTALL A NEW LOWER PINION BEARING UNLESS INSPECT OF THE EXISTING BEARING INDICATES THAT REPLACEMENT OF THE GEAR ASSEMBLY IS NECESSARY. OWNER NOTIFICATION BEGAN JANUARY 24, 2003. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT CHEVROLET AT 1-800-222-1020, PONTIAC AT 1-800-762-2737, OR OLDSMOBILE AT 1-800-442-6537.