vehicle signal
U.S. public vehicle records

Braun ENTERVAN recalls by model year

Explore the records behind recurring owner reports.

Key facts

2 owner complaints analyzed

2 distinct recall campaigns

30,507 mi median reported failure mileage

Scope: 2005 to 2012 model years. Data snapshot: . 2 complaints include usable failure mileage.

Compare model years

Recalls by model year

All campaigns in the snapshot affecting each model year, including recalls announced years later.

Recall campaigns

Shared campaigns appear once in each affected model year.

2005
1
2006
1
2012
1
Recall campaigns data
CategoryCount
20051
20061
20121

2005: 1; 2006: 1; 2012: 1

Year-by-year records

Braun ENTERVAN model-year comparison
Model yearComplaintsRecallsChange in recalls
200511Not available
2006110
201201Not available

Recall history

2 distinct campaigns affect this selection. Announcement dates below are different from vehicle model years. A campaign may cover multiple years.

06V050000 · Fuel System, Gasoline:Delivery:Hoses, Lines/Piping, And Fittings

Reported: 2006-02-14 (February 14, 2006) · Model years: 2005, 2006

ON CERTAIN MINIVANS (BUICK TERRAZA, CHEVROLET UPLANDER, AND PONTIAC MONTANA SV6) BUILT ON PLATFORMS BY BRAUN, A FUEL HOSE CAN RUPTURE ALLOWING FUEL TO BE PUMPED FREELY FROM THE FUEL TANK AND INTO THE AREA UNDERNEATH THE DRIVER'S SEATING POSITION.

Consequence: THIS CAN CAUSE UNEXPECTED VEHICLE DECELERATION OR, IN THE PRESENCE OF AN IGNITION SOURCE, A FIRE.

Remedy: DEALERS WILL REPLACE A SHORT SECTION OF THE FUEL LINE HOSE WITH A SIMILAR FUEL HOSE WITH A HIGHER PRESSURE RATING. THE RECALL BEGAN ON FEBRUARY 22, 2006. OWNERS MAY CONTACT BRAUN AT 1-800-946-7513.

NHTSA campaign record ↗
12V496000 · Seats | Air Bags:Side/Window

Reported: 2012-10-09 (October 9, 2012) · Model years: 2012

Braun is recalling certain model year 2012 Entervan vehicles equipped with aftermarket seat covers, part numbers E51815K-D90-11 and E51817K-11, manufactured from February 28, 2012, through September 21, 2012. The seat covers may have been incorrectly installed with the driver seat cover on the passenger seat and vice versa and will have an 'SRS AIRBAG' label located on the inboard seat bolster.

Consequence: The seat covers were built with special stitching on one side to permit side airbag deployment from the seat bolster. If the seat covers are installed on the incorrect seats, the seat cover will not allow side airbag deployment during a vehicle crash, increasing the risk of injury to the vehicle occupants.

Remedy: Braun will notify owners, and dealers will inspect and correct the installation of the seat covers as needed, free of charge. The recall began on October 31, 2012. Owners may contact Braun customer service center at 1-800-488-0359.

NHTSA campaign record ↗